Recent content by CrackerJackNoob

For anyone information, I copied a lot of what TB has contributed and those who contributed in the thread.

I ordered Omron H3CA with two new 11 socket pin. I probably will post questions about it later. So far my biggest issue is the wiring for the reset.

^Cost and balance is probably the hardest compromise during any operation. I have looked into syphon fed AA but I wanted more control, a bit OCD I guess with the technical stuff. I wanted better control so I am trying to use the external nozzle to fine tune the mist to leave it and forget it...

I am looking for help with an Omron diagram for timing the water system on an aero, simple on and off to control mist/fog. Can't PM. I was wondering if you can host and give a link. I am confuse on the reset. Not sure what I need. Thank you.

I'm heading towards HP for now. I got the nozzle ordered. The AA nozzle company are not getting back. Upgrading to that wouldn't even hard in the future.

Hi. I've been thinking of going into an AA setup. This is last minute. I’m tired of DWC and the amount of water. I have read about the HP setup. There are many good post. I have a compressor in the room for tools, 60 gal 5hp, max at 125psi rated at 90psi @ 18.2 cfm. I don't mind running...

Day 47 in flowering. I'm hoping it will swell more.

Took some pic today. Spent about 2 hrs crushing everything. I hope to have my first 1 pd plant on my first grow. I never seen a really 1 pd plant so yeah :sad: 10 days of flower. I put a shit ton of Nitrogen before Friday before I switch to Bloom nuts. This most likely not a pound, sad...

Took some pic today. Spent about 2 hrs crushing everything. I hope to have my first 1 pd plant on my first grow. I never seen a really 1 pd plant so yeah :( 10 days of flower. I put a shit ton of Nitrogen before Friday before I switch to Bloom nuts. This most likely not a pound, sad day indeed.

I went through some Mg defect when I switch them to these big bucket. I am thinking it's due to the HPS light that makes them need so much Mg. I've been giving them 150ppm of salt. Even my mother needed it under HPS lighting (same coco bucket, turned off mh light to save light since I didn't...

I flip it last Friday. Somehow on Saturday I couldn't upload pic. The Sleestack was all male so I killed it. It's fine since It's my first grow. I'm just a little afraid it might be too compact once everything starts flowering since it's not stretching out. I have another week of scrogging but...

Hi. First time grower and scrog. I am wondering if I should flip it now. Each under 600w hps lighting. I didn't meet my goal with 4.5' scrog, no where close. I know the SS genetics stretch on this NL x Haze. I'm debating if I should just flip it vs letting it veg some more. They are 2 month old...

I'm going to move them back into a 5 gal bucket until Friday when I can go pickup a stronger pump :( General Hydroponics Dual Diaphragm.

Roots of Plant 1 Plant 2 Pump, one per tub

Here is some more photos. It's still droopy and I notice the leaves starting to look like taco which I am thinking it need Mg. I also saw some purple showing on some stem. They never had purple before so I am guessing it is not stain related. Plant 1 Plant 2 Some twist leaves with...