Recent content by Dereek511

If ordered from the site with a driver, and maybe communicated before hand... could those be attached prior to shipping?

Plant+2 main tops, just gave her some water yesterday. I should be close to chopping this lady down right? @fdd2blk Thanks bud

Is this also the fade @Javadog ?

Im not sure how much of a problem this is... but its definitely interesting. Any input is welcome, thanks guys. From seed, 7 gal, fox farm, tap water(+blackstrap a few), week 9ish of flower. Should i be concerned or is this typical *autumn*?

This is the baby that looks the most 'purple', moved her to some weaker lighting+flash. Makes it a lot less purple, and im thinking another week or 2, thanks for the input.

2 different plants here, indoor leds with normal 'rested' tap water, in ocean forest smart pots. At about 100 some days from seed. Does this look like P deficiency or something worse? @fdd2blk should i be chopping them down soon? Thanks everyone

Do you trim the bud leaves to a nice uniform around the bud prior to hanging; and then when dry, proceed to pluck the same leaves from as close to the stem as possible before curing? Im baked, but hope that you can understand that.

Potentiometer needs to be attached to a B series driver to have full control/safety dimming down to 10% of cob power. Speaking of, @CobKits are You going to be restocking ext pots/knobs? Thanks

Sweet set up you've got there. You recommend wire brushing the whole frame? Aluminum angle 1/8?

Atm I've got 2 900w vitraspectra led boxes, and eventually i plan on replacing those with these bars. Ideally i plan on have 3 or 4 of them.

I would suggest building a 12 or 13 COB fixture using 1400ma dimmable drivers with passive cooling in a 3x3 frame. I recommend the 1400B drivers since they are the lowest amperage that can be dimmed to off. For 12 COBs go with 3 rows of 4 COBS evenly spaced. If you're up for the challenge, look...

Alright cool, With that 1400b, i shouldnt need any additional resistors or dimmers right? With a frame i should be able to set it up and go? Edit, doing more reading on resistor/potentiometers.

I see you restocked cxm22 pieces. Ive been reading for some good time and am hoping for a small nudge from you cobkits. I would like to start with 4 cxm22 3000k 90 cri cobs 133mm passives and really looking for a driver recommendation. I found one from Sagar Power systems (?) Hlg-320h-c1400b...