Recent content by diablo69

I've used less without any problems in a closet operation like that. Make sure you have fresh air in and stale air out and you should be good to go. Remember that I'm not a licenced electrician so you might want to wait for someone else to respond but for flourescents and two fans on a power...

It should have read "SOON TO BE EX WIFE" I was joking.

That 's the one I was talking about. From behind she looks just like my son to be ex wife.

quirioushiker, when was my old lady at your place?

I asked a question about building a panel with timer and breaker sub panel but now I can't find it. I looked all over the place but nothing. I am however getting answers from someone asking about other topics. I will include them later as I can't go back without loosing this message. I don't...

Hi, I think you're sending me this info by mistake. I was asking with regard to adding circuit from a furnace shut off, not a tanning room or whatever it was. Thanks, I appreciate your sharing of knowledge and hope that I can reciprocate some day.

I know, if it were my house it would have been replaced long ago but it isn't and I'm not putting out the money for a house that I rent. We're looking for our own place in the country with a nice shop and no neighbours to bug if you know what I mean. Thanks again

It's older wire but not knob and tube. Probably 12 ga from what I remember. I'm not there right now. No room for another circuit. They already put a sub in for the dryer and stove. Only option is to run from that furnace shut off as far as I can see. Sorry I haven't sent the photos yet...

I think there is a little confusion on both ends. There is a throw switch with a 30 amp fuse in the box. The other guy connected a regular receptacle to that circuit and ran it outside. I have disconnected his cable with receptacle, and plan to run my own cable to the terminals in there and...

It has a 60 amp service and the panel is to power the furnace ignitor. It has a 30 amp fuse inside. The other guy had a receptacle on it and ran it outside for x mas lights I assume. I wanted to remove his receptacle and run my own cable to the room I'll be using (20ft away) then just use a...

I would like to wire a panel similar to the first one of two that you posted 4 /7 /09 I have a hard wired timer with three 4 outlet receptacles to power the fans and air pumps. I was thinking about installing a two breaker sub panel, one for the fans etc. and the other for the ballast (1000W)...