setup really wasn’t bad at all. Too many wires. I’m going to be building a panel for the main unit and the ac and lighting adapter to be front mounted with all the ugly seemingly endless coils of wire hidden behind it.
I’m sitting here with all the parts, it looks like a huge pain in the ass. I’m terrible with computers and technology. If you have any tips for setup or problems that I may run into, it would be greatly appreciated
no byproducts along with the co2 with bottled gas. I don’t have to vent the room as often. Just seems a bit safer. Also if one controller failed that means another can fail, not that it will but it can.
I never finished a journal and haven’t seen or touched a plant in about 6 years but am excited to be digging in and getting going again. I’m excited with all the new tech I feel like a kid with so much to learn again. I was about to start a journal and also just had a pretty gnarly fuckup with...
I’ve got a new grow going. It’s sealed and an air dump was to be installed tomorrow. Running 8 Fluence spydr2i fixtures SOG drain to waste in Hugo blocks via Dosatron setup. I’m running GH 3 part Useless formula as it’s basically bulletproof. I’m running a sentinel icg-30 and a Plug-N-Grow...
10x20 room
10" recirculating max fan ceiling mounted
8 wall mounted oscillating fans
room is sealed
1000 ppms co2 via burner
3ton mini split that moves quite a bit of air.
my humidity is 60% at night and 45% during the day
i pulled a clone and am soaking a block overnight in 5.5 and will flush by hand and then water by hand to see what happens. And yes 500 divided equally. My well is 150 and i am at aprrox. 3ml/gal grow 5ml bloom 5ml micro coming in at 500ppms total. I just pumped a gallon into a jar through my...