Just found this today? I just flipped my plants into flower and changed to LED. Is this deficiency or did I burn it? Should I snip them? Also I just gave them full muted for the first time... when they were babies I did 1/3 strength then 2/3 now I went to flower and went to full strength and this happend. Also humidity jumped into the 70s for a couple days. Thanx guys. 1st grow newbie here!
1st grow help!
- Thread starter Norty86
- Start date
Yes
It is a master kush and all the Master Kush I have, happen to have purple on the stem. All the others are fine?
No I don't it's worse then that
Should I pull it? Snip it ?
Wicked_One
Well-Known Member
No it will be fine it's a cal-mag problem for sure.
Either your PH is off a bit and locking it out... or you need to add some.
Either your PH is off a bit and locking it out... or you need to add some.
I keep my PH at 5.8 it gets up to 6.1-6.2 that's it! I think it's my nutes! Fuck dont wanna do a full water swap...
pockitsPM
Well-Known Member
Are you in soil? Most smart people would suggest trying fixing one thing at a time to make sure that was really the issue...if you change your ph, add mg cal, and raise your lights at the same time and the problem is fixed your not going to know which of the three it was ...but that's exactly what I keep doing lol
I raised the light 6" and now adding 5tsp at a time of cal/mag slowly throughout the day . Dose on the back says 5tsp per gallon for nute deficiencies but that would mean 5X30 150 tsp wtf.. seems like if I do that I'll lock it out. Any advice on a good folder spray that won't do damage? Thank you all! My medicine is saving my life... i am in hydro DWC and bubble ponics. Didn't get a problem until I switched to flower nutes.
Cx2H
Well-Known Member
Greetings, sounds like an off brand calmag, botanicare is 5mL per gallon. I use my same calmag for roots as spray at recommend. Can't say for your brand. I mix up a half gallon for spray at 5mL per and one capful of liquid seaweed. Streaks and spots vanish with in 7 days
I will give this a shot! I'm thankful for all the advice! Also my cabinet is getting into the 75% humidity range unless I keep the doors open then it stays around 45-50%. Any tips on how to mitigate this issue as well? I really don't want PM?
Also I am using the B.C brand of everything someone said try this and me not knowing any different tried it... now this.