getawaymountain 16/17 seeders

DankBudzzz

Well-Known Member
used with the water in the machine one cup of juice to 5 gallons water rob roy no clonex or rapid start
I've always struggled cloning but with a little juice in some tap water I got 100 percent rate within 10 days, soil I was at maybe 50 percent or less and it would take 3 weeks. My juice is homemade and not perfected yet so I can only imagine getaways is the rolls Royce
 

DankBudzzz

Well-Known Member
care to share your plans?
Pretty simple and I'm not handy at all. Grabbed a Tupperware at Wally World, drilled twenty holes 1.5 inch I think ? I had the drill and attachment. Bought a air pump and air stone with line for like 16 bucks. Bought the plugs at hydro store for super cheap like 2 bucks for twenty neoprene but those were on flash sale. Super cheap and dimple just bubbles air into the water.
 

natureboygrower

Well-Known Member
Pretty simple and I'm not handy at all. Grabbed a Tupperware at Wally World, drilled twenty holes 1.5 inch I think ? I had the drill and attachment. Bought a air pump and air stone with line for like 16 bucks. Bought the plugs at hydro store for super cheap like 2 bucks for twenty neoprene but those were on flash sale. Super cheap and dimple just bubbles air into the water.
cool ,so you went with an air pump and stones rather than spinners and a submersible pump?i built an aeroponics tub years ago but never had an indoor grow
 

Rob Roy

Well-Known Member
iam buying a cloner this fall,done dealing with peat pots an promix in domes half rot before ready

After many years of doing clones the old school way, we went the aeroponic route about 3 years ago and have been pretty happy. If you clean them good between every run, success rate is near 100%. Amazon has a decent selection too.

Almost time for me to get another one though...the pumps do age. Better to replace them before they die at an inopportune time.
 

Rob Roy

Well-Known Member
Pretty simple and I'm not handy at all. Grabbed a Tupperware at Wally World, drilled twenty holes 1.5 inch I think ? I had the drill and attachment. Bought a air pump and air stone with line for like 16 bucks. Bought the plugs at hydro store for super cheap like 2 bucks for twenty neoprene but those were on flash sale. Super cheap and dimple just bubbles air into the water.
Before we bought a "store bought" cloner , we did pretty much the same thing except we used a pump and pvc sprayer set up rather than air stones. Never got the right plug sizes though so we beefed up the neoprene plugs with duct tape. It worked, but was ugly as hell. Lol.
 

thumper60

Well-Known Member
we got 2 cloning machines and would never go the old way again i got freinds that still go and use cloning powder and promix takes forever and they only get a few weak growing clones out of a whole bunch they start ( try to start ) every time
I get good strong cuts,but takes 2 weeks an20-30 percent loss depending on strain gotta bleach the peat pots before using or they mold 7-10 days
 

thumper60

Well-Known Member
I've always struggled cloning but with a little juice in some tap water I got 100 percent rate within 10 days, soil I was at maybe 50 percent or less and it would take 3 weeks. My juice is homemade and not perfected yet so I can only imagine getaways is the rolls Royce
what u do go to the beach an grab the kelp,i used to do that but never brewed it just tossed it in the compost pile
 
Top