Weird thing going on in veg

Married2MarryJ

Well-Known Member
hey guys so it’s day 17 in veg for my bruja purpura and we’ll im a little concerned. What does this look like to you nute burn? It’s only in 3 out of the 9 plants and one of them was also a really slow starter. I’m using fox farms ocean forest I’m starting to wonder if this soil is just way too hot for seedlings.other than that they still look healthy and growth hasn’t slowed down. Also I have a really strong led in a 2x2x4 tent so it could be the light is too strong also???
3319BBEA-EE9B-433C-A061-5514C4126397.jpeg F6416B16-08D0-4292-AC3A-5B874029CCF6.jpeg
4975725E-7B8A-4FFE-A57B-4115A01EB101.jpeg
 

Tiffj

Well-Known Member
The 2nd pic the soil is too hot for the seedling, transplant to lighter soil it’s getting burnt up! The 1st pic seems to show some rusting on the leaf which could mean an early calcium def, don’t think it’s the light bro.
 
I’m sure someone will try to crucify my opinion but I wouldn’t be writing on a forum if I didn’t expect that, and it’s just that, an opinion.

That being said, I have a DIY two level closet, both top and bottom are 2x2x4 and I have a 4K HLG65 LED in one of which had the same issue.

On two out of the 5 plants I had the same exact problem, I took it as a calcium deficiency so what I did was mix a bit of bud & Bloom Booster fertilizer (I try to use all organic derivatives) with my soil and top dressed the base of the plant and watered.
Also added another fan in my setup because I felt it was too stagnant and the plants could use more oxygen.

The plants seemed to bounce back quickly but I am still keeping a close eye because it just as easily may return.

Pics are before and after. They were taken about a week apart. The plants have grown since then and look good. Good luck
 

Attachments

Tiffj

Well-Known Member
I’m sure someone will try to crucify my opinion but I wouldn’t be writing on a forum if I didn’t expect that, and it’s just that, an opinion.

That being said, I have a DIY two level closet, both top and bottom are 2x2x4 and I have a 4K HLG65 LED in one of which had the same issue.

On two out of the 5 plants I had the same exact problem, I took it as a calcium deficiency so what I did was mix a bit of bud & Bloom Booster fertilizer (I try to use all organic derivatives) with my soil and top dressed the base of the plant and watered.
Also added another fan in my setup because I felt it was too stagnant and the plants could use more oxygen.

The plants seemed to bounce back quickly but I am still keeping a close eye because it just as easily may return.

Pics are before and after. They were taken about a week apart. The plants have grown since then and look good. Good luck
It could be a case of you didn’t fix the problem and it didn’t go any further and the plant grew big enough to take the nutes from the soil and seemed healthy.
 
It could be a case of you didn’t fix the problem and it didn’t go any further and the plant grew big enough to take the nutes from the soil and seemed healthy
“Could” be, but nonetheless you don’t know friend, thanks for your open ended response.
And it seems like you’re giving people half assed information based on looking at a picture.
 

Married2MarryJ

Well-Known Member
I’m sure someone will try to crucify my opinion but I wouldn’t be writing on a forum if I didn’t expect that, and it’s just that, an opinion.

That being said, I have a DIY two level closet, both top and bottom are 2x2x4 and I have a 4K HLG65 LED in one of which had the same issue.

On two out of the 5 plants I had the same exact problem, I took it as a calcium deficiency so what I did was mix a bit of bud & Bloom Booster fertilizer (I try to use all organic derivatives) with my soil and top dressed the base of the plant and watered.
Also added another fan in my setup because I felt it was too stagnant and the plants could use more oxygen.

The plants seemed to bounce back quickly but I am still keeping a close eye because it just as easily may return.

Pics are before and after. They were taken about a week apart. The plants have grown since then and look good. Good luck
These pictures do look similiar
 

BigHornBuds

Well-Known Member
Bottom pick was to hot , (the tips are burnt)
The 1st couple I would say Ca/Mg
Are you using RO water?
I would add a Ca/Mg to your water.

Another thing to consider is that you just popped a bunch of seeds, each pheno will require something a little different.
The 2nd post pic, could have been a runt , so the soil burnt them because they didn’t have the vigor. The ones with the rust , could be heavier feeders and want Ca/Mg

I have a C99 pheno that gets extra Ca/Mg
(Over double what her sisters get)
I have know idea why this one plant drinks it but it does. (Doesn’t overly matter because this is her last run, as I prefer her sisters)
 
Last edited:

Married2MarryJ

Well-Known Member
Bottom pick was to hot , (the tips are burnt)
The 1st couple I would say Ca/Mg
Are you using RO water?
I would add a Ca/Mg to your water.

Another thing to consider is that you just popped a bunch of seeds, each pheno will require something a little different.
The 2nd post pic, could have been a runt , so the soil burnt them because they didn’t have the vigor. The ones with the rust , could be heavier feeders and what Ca/Mg

I have a C99 pheno that gets extra Ca/Mg
(Over double what her sisters get)
I have know idea why this one plant drinks it but it does. (Doesn’t overly matter because this is her last run, as I prefer her sisters)
Sounds good man good thing I bought some mag. How much of this would u feed per gallon?
171BC697-F1A9-4C6E-A65A-006C85027B0B.jpeg 15B8DCC5-66FF-405E-8306-D95823407DEF.jpeg
 

BigHornBuds

Well-Known Member
Are you using RO water?
I have never used that brand,
But start low n work your way up.
I usually give about 0.5ml (per ltr) starting out
As they get bigger, I keep uppin it , till I’m at about 1.5ml going into flower.
If your not using RO water then that could be way to much.

The rust will never heal , but take pics(for reference) n watch for more spots to appear or stop showing up . This will help you figure out the dose.
 

Married2MarryJ

Well-Known Member
Are you using RO water?
I have never used that brand,
But start low n work your way up.
I usually give about 0.5ml (per ltr) starting out
As they get bigger, I keep uppin it , till I’m at about 1.5ml going into flower.
If your not using RO water then that could be way to much.

The rust will never heal , but take pics(for reference) n watch for more spots to appear or stop showing up . This will help you figure out the dose.
I’m using spring water by the gallon Poland springs. Is that considered RO water or is it not. I always thought spring was RO
 

BigHornBuds

Well-Known Member
What’s the ppm of the water before anything is added?
I personally think a ppm & ph meters are a very important part of growing and wouldn’t grow indoors without them.
They give you so much info,
The purpling of the stem on the leaf is another clue saying ca/mg
 

Dr. Who

Well-Known Member
So cal mag issue or soil too hot? What’s your opinion?
It's simply the seedling growing into being able to supply it's self what it needs in the right amounts.

Might start a bit strong in good soil but, like you see. It grow into it just fine..

I say your soil is good for the way it is....The seedlings, have shown they will grow into this soil and recover from any stress, pretty fast......Good to go!
 

Dr. Who

Well-Known Member
Hmm....FFOF soil eh?

Open the bag and spread the soil out..... Now dust the soil with a bit more then 1/2 cup of Dolomite lime.
add a gallon of course perlite (not too course)...

Mix well...

Your soil will have no more Ca/Mg problems.
This is a common problem for FFOF soil...
It will also run low on Ca and Mg later in the run - bloom....

You bought a bottled Ca/Mg that's made with Ca and Mg nitrate.....I avoid those and go for a Ca carbonate based Ca/Mg.....Lower N value and better buffering ability with plenty of Ca available for the plant.

Real good for RO use, especially in hydro applications.....Better pH stability down the road...
 

Married2MarryJ

Well-Known Member
What’s the ppm of the water before anything is added?
I personally think a ppm & ph meters are a very important part of growing and wouldn’t grow indoors without them.
They give you so much info,
The purpling of the stem on the leaf is another clue saying ca/mg
Hey man yea I need a meter I have been using the liquid ph meter so I can’t check Ppm I’m going to
Purchase a meter on amazon.
 

Married2MarryJ

Well-Known Member
Hmm....FFOF soil eh?

Open the bag and spread the soil out..... Now dust the soil with a bit more then 1/2 cup of Dolomite lime.
add a gallon of course perlite (not too course)...

Mix well...

Your soil will have no more Ca/Mg problems.
This is a common problem for FFOF soil...
It will also run low on Ca and Mg later in the run - bloom....

You bought a bottled Ca/Mg that's made with Ca and Mg nitrate.....I avoid those and go for a Ca carbonate based Ca/Mg.....Lower N value and better buffering ability with plenty of Ca available for the plant.

Real good for RO use, especially in hydro applications.....Better pH stability down the road...
Yea I really lime the soil I just want to know how to work with it eventually move to coco. Sounds good man I bought this off amazon the other day what do you think? Good product to use like u said?
6F41F7BE-9527-4060-99D2-A7D8833A0A7A.jpeg FE92BA19-8019-46F9-BE88-422FC7E747D5.jpeg
 
Top