Search results

Hi y'all, Long time grower, first time problem. On the second resoviour for this grow I got it a little hot. Got some clawing! Never faced this prior. No tip burn, just clawing. . Damage done, now I am at 1.6 EC and 5.9 to 6.1 fluxuatiton. Has any faced this, if so what can I expect. I flipped...

Started flower yesterday. Doing initial trim.

Grew this last grow and the one prior, Dos Si Dos! two runs, first was 40.7 zips and the second was 23.5 zips , so a total for the 2023/2024 run was just over 4 pounds. That is cleaned everything removed from the stem, so just buds. I should have given them more veg time and that would have...

Thinking of starting flower 1st July.

Did a bit of tie down today.

The ladies like the tent and light. This was last Saturday, And this morning, and I topped her this week.

The ladies today. The two smaller ones in the top picture were both topped today. The larger one in the top picture and the three in the lower pic are about three weeks ahead of the two smaller ones. Have the mother and she is ready to give up about 6 clones. Will take a few clones from the...

Put the clones in their final pots today. Started the clones off the mother from Carver Farms in Albuquerque in early May, 4 took off right away but the others I have taken since have been very slow. The mother, will take a number of clones from her over the next few months for the spring grow...

All clones and mama CCC lines taken in the past week, one for sure is rooting need at least one more. Two clones ready for the tent, will be topping the original 4 clones soon. And the other two ready for the tent. Hope to begin flower by July 1st. Just need the two newest clones to take off.

I use a coco/Perlite, 75/25, during mid veg I am doing 6 to 8 nutrient solution cycles, during flower, doing 4 to 6 cycles. I use 1/4 recommended nutes, not motter which nutes I use, using GH Flora series now. Never let coco dry out, needs to be kept hydrated for optimal growth.

Took 6 clones yesterday and soaked them in solution overnight and planted them today. All clones and the Mama. The four clones at the corners were taken 8 days ago and are rooting. The 6 plants in the center were taken today. If all comes to fruit I should have them in 2 gallon Smart pots in...

Got four of the five clones to take, just got back from my trip. Will take more clones today.

Yes, I transferred them in a cooler and all was good

Has anyone made CCO using a alcohol still? I have access to this model. https://a.co/d/2sIz4f4 What do y'all think?

5 X 5 Gorilla Grow tent, HLG Scorpion Diablo (650 true Watts), 6 plants drain to waste Clone: Carver Family Farms Dancing Hands grown in a 5" pot of Living Soil. Grow Medium: Coco/Perlite, 75/25 Nutrients: GH Florida Trio, KoolBloom liquid and dry, Cal mag/Magnesium, pH range float from 5.8 to...

Crop steering?

I have been running coco for years now, I have an automated irrigation system that allows me to water as many times, up to 8 times per light cycle. The master board. Orbit 8 port manifold, only use 6 with the current setup. Rainbird emitters, good full pot coverage. Setup, modified Ebb and...

The clone is in a 5 inch square pot. Will the difference between that coco and soil interface cause issues.

It is in a 5 inch square pot. Am thinking if I cannot wash, then go ahead and grow in this pot and take clones from the mother and put in coco.

So there should'nt be a problem with a 5 inch pot of soil planted into coco, will it cause root problem with the wet and dry cycles. Soil holding water much better than coco.