befor i order

Hi guys and girls

Have been reading the forums here and at other sites planning my first grow.
Am hoping to do a vscrog due to lack of floor space.

ok on to the set up.
the floor space is only 30" x 20" x 72" so as you can see i am short on floIor space but plenty of hight.

I would like to attach scrog screens on 3 sides with a 4 " air gap between the screen and walls.
The 3 screens would give me a total area ( 52" x 48" ) of about 17 square feet.
Walls covered in diamond mylar


My equipment list is as follows

: Min/Max digital thermo / hygrometer
: 100mm Wolfnado fan + filter 155/295 m3/hour
: 2x 250w cfl 2700k (will have seperate clone room with 125w cfl 6500k)
(will be upgraded to 2x150w hps)
: Canna nutes
: Bio Bizz Light-Mix soil
: rockwall plugs
: 7" square pots


I am hoping to grow 5 plants in this space grown verticaly up the wall screens (48") as shown below ( i hope )


Any comments good or bad most welcome befor i order the kit do you think this setup would work ok ?

What strain are you planning on growing or is this gonna be a bagseed run?

Instead of 2 150s i would go with a single 250w
The single 250w would have less heat and more penetration,Also would result in larger and harder buds

i was thinking that 2 150s would have been better as i could hang one above the other to provide light the full hight of the screen (4ft)

Yea, that looks good. You'll def need the 2 bulbs for all of that vertical coverage.

But with this kind of setup, with all the vertical height, won't you want a little more sativa in your genetics?

was going to make it shorter to start with but after reading about a few grows alot outgrow the screen i have the hight so its there if i need it better i think than not having it and needing it