Check your work

WillieNelson

Well-Known Member
I work on live DC circuits all the time ;-)

...Of course they're only between 5-12Vdc...but they're live, does that count?

Im trying to set my whole garden up in DC, with a bunch of power inverters and maybe some car batteries.. any suggestions?

I am thinking that an extremely large hamster wheel hooked to an induction motor would do just fine. Big enough wheel for a crackhead. Put a rock in front of the whell and watch them run!
 

lorenzo08

Well-Known Member
I found humor in the drawing in the gallery here of a guy using a 220v plug to run 2-110v lights. Not that it wouldn't have worked, but just a little unstable to series connect my lights.
actually, I do something similar to this. last fall I moved into the house I'm at now. when winter came, I had problem after problem with pipes freezing. by the time spring came around, I had either replaced or reinstalled every pipe in the house and properly insulated everything. there is a section of pipe, the water main coming out of the ground to the house. it was exposed to the cold air with only a torn up heat cord and some pipe wrap falling off of it. I built a box around the pipe with plywood and insulated it. I put 2 porcelain light socket in the box and wired them in series 120v, so they each run at half power. they're not as bright, put off about the same amount of heat, use less power then normal, and last much much longer. my dad has a single bulb in a similar set up. he replaces it probably 3 times over the winter. mine haven't blown out once yet, but, if one blows out, the other will go out too.

I also plan on building a bud dryer when it comes time for it. I might use a few small halogen bulbs for heat. maybe 3 sets of 2 bulbs in series, running on a powerful 12 volt source. should be enough heat.
 
Top