Get a Harvest Every 2 Weeks

Status
Not open for further replies.

videoman40

Well-Known Member
This is wrong.Your power usage quotes are flawed, it largely depends on the quality of the ballast, as this could flucuate ALOT.
Also your coverage is flawed too.
You’ll get better light coverage with 2-400’s. better yet, 2-600’s. The great thing about the 600’s are they put out the same amount of light as a 750 watt HID would if you based it on the efficiency of a 1,000 watt HID. In other words, you'll get 75% of the amount of light from a 600 as you’d get from a 1,000 at 60% of the energy cost.

A 250 watt HID will illuminate a 2' x 2' garden.
A 400 watt HID will illuminate a 3' x 3' garden.
A 600 watt HID will illuminate a 3.5' x 3.5' garden.
A 1000 watt HID will illuminate a 4' x 4' garden.

You can see from this how 2 400's or 600's would be better than a 1000 watt light.

You'll put less heat into the area using a single lamp than with multiple lamps of lower power output. There's a certain inefficiency in all HID lighting- some power is wasted as heat. That efficiency factor is poorer per lamp watt in 400s and 600s than in 1000s. You can remotely locate the ballast, outside the grow room airspace, to mitigate that effect somewhat as the waste heat from that inefficiency comes mainly from the ballast. You have the aircooled hood happening already taking care of the rest.

A 400 HPS will be using about 500-530W power input to the ballast from the mains AC. A 1000 HPS uses about 1100W from the mains. You could be putting down significantly more lumens with a single 1000 than with a pair of 400s for almost the same power cost. A 1000 has better foliar penetration and will make tighter buds than a pair of 400s to boot.
 

Al B. Fuct

once had a dog named
This is wrong.[...]

A 1000 watt HID will illuminate a 4' x 4' garden.
Oh, of course, you're right, silly me. I must have been relying on the pot gnomes to light two of my 4x4 tables. :lol:

Get out of your growbooks and run an op for a while (like about 10 years)- you'll find out what works and what is just a booklearned wank.

Simple as this- 50W per sqft of HPS for a flowering area is ideal, 40w/sqft will do fine.
 

Al B. Fuct

once had a dog named
Just to be clear, my op has four 4'x4' trays in the flowering area. Each pair of trays is lighted by a single 1000. Works fine.

Absolutely false that a pair of 400s will work better than a single 1000. Due to ballast wastage as heat, you use almost the same amount of power from the mains- for 200w less light. A 1000 makes ~150,000 lumens, a 400 makes ~50,000. It'll take about 1100-1200W to run either a 1000 or a pair of 400s. Why would you willingly settle for 50,000 less lumens for THE SAME power input to the ballast(s)?

Silly, silly, silly.
 

Al B. Fuct

once had a dog named
This little twist in the thread brings to mind a problem I've always had with cannabis growing forums. Because there's few really definitive cannabis grow guides- even Ed Rosenthal's older stuff is now largely disproven- everyone THINKS they know best.

I'm not going to get into wankfests over 'plant available watts' or other such nonsense. When you go out to buy HPS lighting, you get one useful figure you can use for broad comparision- and that's the lumens number.

I'm going to claim I know better than MOST of the growbooks, for one simple reason. I've been running a highly productive grow op since about 1997 (with pix posted in my gallery)- as well as a few really ordinary ones for a couple of years before I got it really nailed down.

There's only one growbook I trust- 'Indoor Marijuana Horticulture' by Jorge Cervantes, Robert Connell Clarke and Ed Rosenthal (ISBN 1-878823-17-5) though my copy, dated 1993 (and autographed by my pal Jorge, can you believe it?) is starting to show its age.



 

abudsmoker

Well-Known Member
agreed 1k is superior to 2 400w it would take 1200 watts to equal the output. and a 1k foot print is 5x5 easy
 

Al B. Fuct

once had a dog named
Well, SHIT. My entire photo gallery has been deleted except for ONE pic of my mums!

WTF?!

I delete pics from my local HDD after posting for security reasons. I can take more pix, but what a pain in the ass.

Hey Admin, what's going on?
 

akidynoken

Active Member
well I went ahead and shoe-horned ths 1000 watter in my space, and it just raised the temps maybe 3 or 4 degrees no big deal, I've also got clones just about ready so I had to redo my old veg space with a 400 sodium just to get started whilst my other grow still going. when thats over i'll just move everything to it new home with the bigger light, never thought the 1000 wold be so much brighter than 800 but man it is. Cant wait to get this other grow started, as ive really been wanting to do this kind of grow, thanks for all the info, youve helped out alot!!!!
 

Al B. Fuct

once had a dog named
a 1k foot print is 5x5 easy
Thanks for your comment abs.

While the 50W/sqft rule of thumb is the ideal, anything over about 35-40W/sqft of HPS lighting will give good results in a SoG op.

The SoG technique, where lower branching is pruned off early in the flowering cycle, greatly increases the airflow around the plants and also reduces shading of the parts of the plants (that are not pruned off). You can get away with somewhat less than the ideal 50w/sqft figure because of the removal of excess foliage.

The main part of the plant grown in SoG- the big fat colas on the top of the mainstems- will be getting plenty of light at 35-40W HPS per sqft.
 

Al B. Fuct

once had a dog named
well I went ahead and shoe-horned ths 1000 watter in my space, and it just raised the temps maybe 3 or 4 degrees no big deal, I've also got clones just about ready so I had to redo my old veg space with a 400 sodium just to get started whilst my other grow still going. when thats over i'll just move everything to it new home with the bigger light, never thought the 1000 wold be so much brighter than 800 but man it is. Cant wait to get this other grow started, as ive really been wanting to do this kind of grow, thanks for all the info, youve helped out alot!!!!
That 3-4 degrees can be a problem... like I said before, keep an eye on your air temps. Use a digital thermometer which has a peak memory feature. Increase your ventilation capacity if you can't keep air temps under 28C.

Those 1000s are EFFING bright, aren't they? :lol: Seriously, don't look at a burning 1000w lamp if you can avoid it. Wear a cap with a visor in your op to protect your eyes.

The 400 will raise mother plants just fine for you. A 400 HPS has worked for my mums for a lot of years, but one could probably get away with a 250 MH or HPS.

Happy to share any info with you that I can!
 

TillthedayiDIE420

Well-Known Member
Great thread AL B. you should invest in a digital ballast lower cost, more lumens, only takes 3 seconds to boot up the bulb unlike magnetic, when a Magnetic bulb is booting up it is using more watts then if you left it running for 24hours.... which is why a digital is better for ya, dont take this the wrong way it is just an idea, you've been growing 5 years longer than i have so ofcourse you know best. just something to think about :P
 

Al B. Fuct

once had a dog named
Thanks for the compliment, TTDID420.

I've been looking at the 'digital' ballasts (which look to this old techie like a variation on a PWM power supply). The better efficiency factor is very persuasive. No question, when it comes time to replace the existing units, I will very likely be upgrading to the newer type.
 

Al B. Fuct

once had a dog named
Now this is weird... all my gallery images except for a pic of my mums when ready for a pass of cuttings have gone *poof* but 2 of my images (which appear in the 1st post of this thread) are still there.

hmm.
 

akidynoken

Active Member
it is easy to control the temps in my space by changing the temps on the outside, the outside room is to easy to climate control, it is airconditioned and heated with natural gas, all the convience of home, right now it is 74 degrees in there, not bad eh. It is going to work, I just know it
 

Al B. Fuct

once had a dog named
Yeah, sounds like a plan. It will work, no doubt. 74F is ideal.

The only problem with sharing the heating/cooling for the rest of the house is scent control. The whole house is sharing the grow op's air.

If it were my op, I'd be looking into building a high volume UV ioniser. You can buy Ozonaire (or other brand) ionisers, remove the UV fluoro tube from the small PVC tube it is built into as supplied and mount the tube in a big piece of steel duct pipe. The UV tube will make enough ozone to knock down the scent even when dealing with a several hundred CFM exhaust blower.
 

videoman40

Well-Known Member
It is absolutely false, a 1000 watt light emits 11k lumens at about 22 inches, a 400 watt emits almost 17k lumens at one foot.
17k x 2 = 34000 lumens, so you'd need 3 1000 watt lights to equal 2 400 watt lights. Hmmmmmmmm
I used these as guidelines only. my light is actually much closer, but I wanted to keep this fair. I am sure you can squeeze a few more inches for the 1000 watt also, but it'll never catch up to the 400 watt light. If it were me though, I'd be using the 600 watt light, not the 400 or the 1000.

Also you state that "the 50W/sqft rule of thumb is the ideal" it is not the ideal it is the minimum.

Just to be clear, my op has four 4'x4' trays in the flowering area. Each pair of trays is lighted by a single 1000. Works fine.
Absolutely false that a pair of 400s will work better than a single 1000. Due to ballast wastage as heat, you use almost the same amount of power from the mains- for 200w less light. A 1000 makes ~150,000 lumens, a 400 makes ~50,000. It'll take about 1100-1200W to run either a 1000 or a pair of 400s. Why would you willingly settle for 50,000 less lumens for THE SAME power input to the ballast(s)?

Silly, silly, silly.
 

Al B. Fuct

once had a dog named
dont take this the wrong way it is just an idea, you've been growing 5 years longer than i have so of course you know best. just something to think about :P
BTW, I'm not not real fussy about who is right and who is wrong. It's not about the people- and it's certainly not about ME. I don't post this stuff to be right or wrong, to be respected or not. I post it so others can replicate a grow op that works very well as a result of a a few years of trial and error and several more of smooth, reliable operation.

I DO care about what information is right and wrong, though much of it is bell-curve stuff. Not everything is cut-and-dried (so to speak); a range of parameters may work OK. However, if someone comes up with something that's just way out of the ballpark (or simply in error), I'll usually say so, more or less diplomatically. ;)
 

Al B. Fuct

once had a dog named
It is absolutely false, a 1000 watt light emits 11k lumens at about 22 inches a 400 watt emits almost 17k lumens at one foot. I used these as guidelines only. my light is actually much closer, but I wanted to keep this fair. I am sure you can squeeze a few more inches for the 1000 watt also, but it'll never catch up to the 400 watt light. If it were me though, I'd be using the 600 watt light, not the 400 or the 1000.
Where are your figures coming from?

I'm referring to figures I have on some Philips and GE Lucagrow datasheets. Looking for an equivalent online resource to link you to. A 400 looks like about 50-58,000 lumens, the 1000 is 150-160,000 lumens.

Also you state that "the 50W/sqft rule of thumb is the ideal" it is not the ideal it is the minimum.
umm, sorry, that's crap.

Your absolutist statement would lead the inexperienced to believe that absolutely nothing will happen at 49.994W/sqft- and this simply isn't true.

Once again- get out of the grow book and into the grow room, OK?
 

videoman40

Well-Known Member
Your making me wonder if you've ever grown anything under artificial lighting.
The lumens output you speak of is at the bulb, not at the plant,
I actually thought this was understood. I am not disagreeing with your stated lumens,

a 1000 watt = 150,000 lumens.....at the bulb, agreed?
a 400 watt = 55,000 lumens.....at the bulb, agreed?

As you move further & further away from the light source, you loose lumens.

Again....
the "usual safe distance" for a 400 watt is 12"
the "usual safe distance" for a 1000 watt is about 24"

a 1000 watt light emits 11k lumens at about 24 inches
a 400 watt emits almost 17k lumens at one foot
17k x 2 400 watt lights= 34000 lumens

Again....you'd need 3 1000 watt lights to equal 2 400 watt lights.
Silly, silly, silly.

Peace

 
Status
Not open for further replies.
Top