Pump Needs

muleface

Well-Known Member
I have 36 bato buckets, I am looking for a pump that can handle that amount of water movement. I am looking at ecoplus units, but I am thinking that i might need a more commercial/industrial grade pump. The design will be 1/2 piping to all the buckets in 2 big loops, with 2 water outlet to each of the buckets, so 72 - 1/8 flex lines in total.

These are on 2 - 3x12 tables, I have 110 gallon tank that will supply

any suggestions on pumps? or design?

it will look something like this...
 
Last edited:

FennarioMike

Well-Known Member
I'm assuming this is a drip system that recollects a drain back to the rez? I'm thinking that the Danner 250 gal/hr would be PLENTY - but you can calculate what you'll need by figuring out actually how many gallons/hour your drip will be and multiply that by the # of drippers.
 

muleface

Well-Known Member
This is DTW. I have a 1000gph pump from ecoplus. It doesn't seem to do the job. Perhaps my design is to blame
 

Airwalker16

Well-Known Member
I have 36 bato buckets, I am looking for a pump that can handle that amount of water movement. I am looking at ecoplus units, but I am thinking that i might need a more commercial/industrial grade pump. The design will be 1/2 piping to all the buckets in 2 big loops, with 2 water outlet to each of the buckets, so 72 - 1/8 flex lines in total.

These are on 2 - 3x12 tables, I have 110 gallon tank that will supply

any suggestions on pumps? or design?

it will look something like this...
Harbor freight .
 

FennarioMike

Well-Known Member
This is DTW. I have a 1000gph pump from ecoplus. It doesn't seem to do the job. Perhaps my design is to blame
It's something in your design. The plants definitely don't eat 1000 gpd. Maybe because it's a closed loop it's bushing against a dead end? I'd think you'd need to bleed those lines to get any flow to them. What about making it a recirculating loop that returns to the tank with a valve at the end to partially close to create back pressure?
 

FennarioMike

Well-Known Member
It's something in your design. The plants definitely don't eat 1000 gph. Maybe because it's a closed loop it's bushing against a dead end? I'd think you'd need to bleed those lines to get any flow to them. What about making it a recirculating loop that returns to the tank with a valve at the end to partially close to create back pressure?
 
Top