seeds after grow very thin.. help please

nightfun

Well-Known Member
Have 5 seeds that were germinated. Put them in soil and all have spouted. I have them in a tray with a dome sitting on a warming pad. Temp is good 80 degrees humidity is 90% also have cloans in there too.

The issue is the seeds that sprouted are thin and I guess should be. Question is how do I get them to not be so thin?

thanks
 

Firsttimer

Active Member
They are supposed to be thin to start. Give them time. Are you giving them light yet, and are you going to start them with flors. If you do, you can get that light right up close to the plants, like an inch away with a little fan. If not then they will stretch and than you will have a problem with to thin of a stem and you will have to support the plant somehow. Hope this helps.
 

nightfun

Well-Known Member
yes helps a lot! I am using flos (2) they are about 1/2 inch over the dome. which is about 3 inches over the top of them. a fan? I've been reading that cloans need to have a high % of humidity. If i open the dome and run a fan through there, the humid. will drop consideraly.. won't it?
 

nightfun

Well-Known Member
They just need light, a fan and time.

thanks.

i have a follow up, i search but could not find.

Once I put them in 3 gal bags, how deep should i put them? Meaning, how much of the stem should get burried?

Thanks again
 

kingpapawawa

Well-Known Member
clones and seedlings need different environments. get your seedlings out of your clone dome, closer to the light and a fan to strenghten the stem. bury them so the first set of leaves are laying on the surface of the dirt
 

420penguin

Well-Known Member
clones need a dome and a lot of humidity. seedlings need what everyone else has said. warm soil, a fan, regular moisture, fluoros quite close and you should be fine.
 

nightfun

Well-Known Member
thank you all very much. I did not know about keeping the seedlings seperate from cloans. I'll be changing over everying today.

appreciate everyone's help
 
Top