shroom print question

So i can only vague on this question but here goes.

Pf tek style b+ shroom

To print do i pull the cap off put it on foil wrap it up and put it in a dark place?

Then to use them just put em in water and load it up in a syringe?

im here .
Basically what you NEED is
- a syringe
- a piece of printing paper
- a cup .
- scalpel , or exact o knife
- fresh cap (wet) or a fresh dried cap <-- wet is better.
- alcohol lamp

#1 sterilize knife using the lamp .

#2 cut the cap off , possibly leaving part of the stem (doesnt need to be perfect)

#3 place it gill side down on white printer paper (if using freshly dried add 2 drops of water to the TOP of the cap -not the gills).

#4 place cup over cap . (to prevent spores from blowing away)

#5 wait 24/hr

#6 sterilize water by boiling it , then wait for it to cool .

#7 sterilize syringe(via lamp) then draw 10 cc's of water

#8 scrap the accumulated spores into the cup , then add the 10 cc's of water

#9 release the water from the syringe around the inside edges of the cup to collect any spores stuck to the sides .

#10 do this three times . (by redrawing the SAME 10 CCs of water !)

sterilization is absolutely key , shorts cuts = contamination .

I highly recommend purchasing "the mushrooms cultivator" <- great book

hope it helped =)