Too much nitrogen, revegging? Bad genetics? Cut a nug off and wait 2 weeks to dry it. Then smoke it and then see. Are you going to flush to try and get some fade ?
Spread the branches down and tie. Cut off a lot down below. Fill out the 3x3
How many inches or bud sites can an LED penetrate ? Maybe 6-8 inches? Everything below that is _________
I never use a bag. I would also like a bag less mold that you can really fill up. Have little holes at the bottom. Have the heat things be drilled into the mold. The press won’t have plates. It will have the mold. Hire me Dabpress.
All those tall tops, bend them under the screen now or they will reach to high. That’s the point of the mesh. Fill all the empty spaces. You want it to be flat now.
I’m not sure how many Gs. It’s a good size pile.
I have some bags. But I have never used them, I am too cheap. The stuff I have I am deeming low quality, I am just practising. I am saving the bags for the AAAA+++ stuff that I grow next. :bigjoint:
here I am at it again. Rawdogging not wrapping it. Well, this batch is harsh to vape. Burns throat and no good taste. I seem to have better results with flower rosin rather than with this tumbler hash.
And You still get to bake with the pucks.
So you are using the shaking technique. I have been trying to go with the rotating drum. Maybe I should switch to your method.
“It all depends”
It’s all energy man
I think the energy that went into the larf at the bottom could have been redistributed to the location of the big nugz at the top.