obviously done like transgender Yippies, here
s&p td silent will do for a 600w hps?
Monday's are not going to exist when I retire!
Looking 4 hlp with ggzkittles.. new to the indoor thing.. running 4x4tent with 1700watts LEDs
Welcome back. It's good to see you!
Life isn't measured by the number of breathes you take, but by the moments that take your breath away Anonymous
Oops I can post:
Im in Oz, new user so cant post.....
Me again, 324s have been discontinued.. whats my best option for a 5x5? HLG600 or 2 x 288V2 triples or do I look at 304s?
Are you in the US or elsewhere? Might depend where you are, as there are other options to HLG boards.
Two triples would work, but I'd run a bigger driver. We run 40-50W/sqft for all our rooms, so 24W/sqft isn't much for a 5x5. You should ask these question on the forum, I can't really answer in 420 characters or less.
Hi there are you using pcg clones?
Life is what you make it
When do you expect to have the 324 boards / kits back in stock?
On ya bud, looks like I will just buy 2 kits of doubles then. Do you think the 324s will be ok to veg for 4 weeks prior to flip? Hoping this will be equivalent to a DE 1000w HPS or close anyway.
It's a myth you need 5000+K to veg. More red actually yields more bio-mass, all other things being equal, but at the cost of slightly longer nodes. You won't have any issues vegging under 3000K.
4x QB324s running at 175W each should easily replace a 1000DE HPS, not least because they will give a better spread of light. We were running 600W DEs and 2xQB324s running at 400W have equaled them in yield.
Hey Cob, wondering if I can pick your brains, what driver would you reco to run 4 x 324 boards. I would like to fit 4 of these boards to the HLG600 kit instead of the V2 288 and run them off the HLG-600-54B driver - will this work? Ideally I want to be able to run these 4 boards off one driver with an external pot.
You can't use that driver on the QB324 boards, as they are 108V. We are running a HLG-480H-C2100A for two boards wired in series, dialed back to about 1.85A for 400W total. That is the biggest HLG CC driver you can use.
IMO, you'd be better off buying two HLG-320H-C1400 drivers for each pair of boards and driving them two in series off each driver. That would give you 700+W potential, or just over 175W per board.
Funny, you have 3 posts and all of them are about a trimmer.. Where are the sample units?
I’m a ultra trimmer owner and I have to say hands down is the far best trimmer out there in my opinion
Well then, how many trimmers have you personally used to trim buds?
Frustrated.. heat burn, recovery, now when to flower
8 for 8 germination rate . . . Got to love that!
Separate names with a comma.