DarkWeb
Well-Known Member
We had orange carpet in this place lolI think i lost all the pics of before and after of the Paradise house I COMPLETELY remodeled. It was the absolute worst of the early 70’s before
We had orange carpet in this place lolI think i lost all the pics of before and after of the Paradise house I COMPLETELY remodeled. It was the absolute worst of the early 70’s before
Try Lincoln or Roseville.no hotties i run into anymore in that situation especially around here.
I picked out my floor tile in the rocklin floor and decor.Try Lincoln or Roseville.
I've seen some hotties in Home Depot in Lincoln, same with Lowes, not sure if they were up for some slap and tickle.I picked out my floor tile in the rocklin floor and decor.
nothing magical happened.
I’ve been thinking I need to hang out at or near the hospitals. Nurses make the best companions plus they make bankI've seen some hotties in Home Depot in Lincoln, same with Lowes, not sure if they were up for some slap and tickle.
I completely wipe everything off, and installed windows 10 again. It took all damn day to do it lol.Have you considered running Linux on it?
It’s all Yoko Ono’s fault!Stones aren’t blameless, and don’t get me started on the Door industry
Did the computer reset? Just like clearing a code or disconnecting the battery. Run it for a few days.I tried to replace the EVAP pump on the truck, it is still throwing a code. I did everything I could think of the disconnect the connector on it and I can't budge it. I guess it's going to the shop to do a 10 minute job.
Yes, I reset it with my scanner. They found no leaks and said it might be the pump, which is why I tried to replace it.Did the computer reset? Just like clearing a code or disconnecting the battery. Run it for a few days.
It might take some time to have everything sync up again. I had a jeep that I put a battery disconnect in and every time I went to get it inspected I'd have to drive it about 150 miles for everything to work together again so the inspection scanned correct. If you plug your scanner back in.....does it say "not ready" for anything?Yes, I reset it with my scanner. They found no leaks and said it might be the pump, which is why I tried to replace it.
It shows a code after setting the sensors.It might take some time to have everything sync up again. I had a jeep that I put a battery disconnect in and every time I went to get it inspected I'd have to drive it about 150 miles for everything to work together again so the inspection scanned correct. If you plug your scanner back in.....does it say "not ready" for anything?