Viparspectra par1200 (550w), hanging 1 meter above the canopy. It was running at 100% veg and 60% bloom. I turned it down a tad on both last night, I’d say 80% veg and 40% bloom now.
Have 4 clones that have recently gone into the veg tent, all in coco/perlite that was rinsed and buffered together and all of them have been fed the same mix of nutrients. They all have a little droop to them, I’m guessing from a little too much water but it’s also pretty warm in there. This one...
planning on pressing a half oz of bud tomorrow with my Dulytek 7ton, any tips before hand? (Temp/length of press etc).
I over-dried my buds a little and the curing jars are sitting at 60% rh or just under at only 1 week in. Should I add a boveda pack before pressing?
Think the terminology is a little different here, this is what I mean by rocket pot.
which method did you find gave you the best results? I just finished up a grow with 5x 15L pots and also watered once a day with pretty good results. Would you recommend watering more often in smaller pots over...
I scraped them with a steel wire brush and ran them through the washing machine twice to no prevail. My old ones that were larger were the same deal. I’ve just come to the understanding that the plastic air pots will last forever and the fabric pots will eventually get too worn.
I grow in coco/perlite and have been hand watering the entire time. I’ve decided it’s time for an automatic watering system so Ill be buying some new pots. I’m thinking of getting the rocket pots.
The past few grows I was using 4 gallon pots and fertigating once a day. So I have 3 questions...
Would one of these pots be a better route or do you find just a basic plastic pot works best? I’ll be implementing an automatic watering system during this next grow.