A question about the Vesta strips BXEB-TL-L0280Z-2750E1000-B-C3

Rocket Soul

Well-Known Member
Hello people, i´m building a small light with the BXEB-TL-L0280Z-2750E1000-B-C3 strips , and i want to set them on the 2750K range only.
The first mistake was after i thought the ´ C ´ connector was color and the ´ W ´ connector was white , but offcourse the ´ W´ means Warm White.
So i connected the wires on the ´ W´ connectors . The color looks warm white but all the leds are on ?

Is this normal? I thought that only the 2750K leds would turn on ?
I connected them in parallel and have 9 of them connected on 375 Ma each strip .

Anyone have an idea , especially those who use the Vesta strips them selfs?
So no connections to C + and C- and still light from this channel? Thats very strange... Id rec going over everything again to make sure. The 2 channels should be separated, should never get light in both if you only connect one channel


Are you with parallel connections or series? Whats your driver?

No matter if you connect in series or parallel it would be a good idea to group all + and - for each color in one group with wagos and add some kinda switch in front: that way you get 3 different spectrums: WW, CW or both at half current each. Basicly full flower, seedling/stretch control and both channels for a full cycle spectrum just under 4000k.
 

nederwierie

Active Member
After i looked closely on the pictures i count 14 leds up to the connector but with the light on i count only 7.
I think it´s an optical illusion that it looks like all leds are on. My mistake, please close this topic mods.
 
Top