Air line fitting on rosin press

trambles

Well-Known Member
I got my pneumatic rosin press today.
I'm confused on how to hook up the air supply. It doesnt have a standard nipple one would find on air tools.
Somehow I'm supposed to hook this to a compresor.
Any ideas?
20201210_175646.jpg20201210_175646.jpg
 

trambles

Well-Known Member
I have some fittings like that and they dont fit. I unscrewed the inlet on the press and attempted to screw in a standard nipple and it's too small
 

trambles

Well-Known Member
The press has a hose that slips into the regulator, almost like a shark's bite connector, so that end is no problem.
My issue is how do I connect the pictures hose to my air compressor?
 

DarkWeb

Well-Known Member
The press has a hose that slips into the regulator, almost like a shark's bite connector, so that end is no problem.
My issue is how do I connect the pictures hose to my air compressor?
Yeah I know how it works....answer my last question.
 

trambles

Well-Known Member
O, I removed the elbow on the inlet side of the press regulator and attempted to screw in a male air line coupler. The hole was too big for the coupler20201210_175643.jpg
 

trambles

Well-Known Member
Sadly the instructions are quite limited and there is no spec sheet except that it requires 150psi and 220volts.
But that's far improved from my rotary evaporator which had zero instructions whatsoever.
 

trambles

Well-Known Member
Well I figured it out, that threaded end accepts a female nipple and I just put some couplers together I had in my garage. Not sure if this is the way it's supposed to be but it will get the job done20201210_194204.jpg
 
Top