Recent content by Australias

Hey im from adelaide too. Just leaving a message to say Gday :)

Refer to this - https://www.rollitup.org/marijuana-plant-problems/418643-have-plant-problem-check-here.html

Refer to this - https://www.rollitup.org/marijuana-plant-problems/418643-have-plant-problem-check-here.html

Refer to this - https://www.rollitup.org/marijuana-plant-problems/418643-have-plant-problem-check-here.html

The only thing i could think of is to flush your plant. but im no expert. Refer to this - https://www.rollitup.org/marijuana-plant-problems/418643-have-plant-problem-check-here.html

Is your light a propper light for growing? is it a fluorescent light? . 12 inches away is abit too far away if it is a fluorescent. You need to be abit more specific when you say your leaves are dying. What do they look like? can you post a picture

Refer to my thread. https://www.rollitup.org/marijuana-plant-problems/418643-have-plant-problem-check-here.html

Just Found, 5 caterpillars and tons of spider mites on my plant, and a caterpillar which made a cocoon under one leaf. Its amazing how infested your plants could be without knowing. I looked under a few leaves after getting all brown spots and discovered my plant was being eaten alive!! As bad...

How far away should my 250w HPS light be from the top of the plant while flowering?

I was just wondering. If im in my room, and open my window which lets light into my room and through the center crack between the two doors in my cupboard. Its not direct sunlight, just ambient light, how bad is that? And also, if my window is open and i open the cupboard for about a minute to...

On behalf of myself and the RIU community id like to say sorry for your potential loss. The characters you described in the story sound like complete retarded, heartless, ignorant bastards! i cant begin to imagine how hurt you must feel inside! I for one am very angered about your situation. My...

Common Plant Problems The problems that plague growers are myriad so it is difficult to say what the best approach is to this topic. Perhaps the best approach is to make this guide practical for troubleshooting purposes. To this end. You should first find the part of the plant or type of...

Doesnt anyone here use a ballast or what?

I have a single plant in its flowering stage under a 250w HPS and ive noticed when i touched the ballast that it is putting out alot of heat, i touched the bottem of the ballast and it was so hot that it is very uncomfortable to keep my hand on it longer then a few seconds. Is this normal? Ive...

MasterHemp what happened to g0dl1ke? ^posted that the exact second you inbox me. scary. Lol