Recent content by grasscropper

Done! It’s very damp here currently. Was away and came back and took that and some other areas down. Not too bad but she can’t take much more weight or wind.

I know! It’s down. I am a woman. Hahahah.

Romulan without a doubt. Haven’t fully harvested yet. Probably will do this weekend.

We are working on it. Have learned from this one. She’s so big now that finding stakes this long and strong has been difficult. These were homely ladies at the start. Hahaha. Now does one start staking when small and keep going along the growing

These girls are truly stunning. Last Of the line too Good morning fellow growers!!!

The reallllky annoying part is I gave 2 of my crappiest babies to my bro. For a trial run. And bam. We have these monsters. Haven’t seen bigger in my life. Trimmed branches beyond repair. And hey it exposed some of the inner area. And we have trimmed back fan leaves all summer!

These were stunning plants. Terrible. Broken hearts this morning. Bloom or flowering started early this year which is good as we can crop out earlier as well.

Hey growers. I have a Romulan. Two actually that took a beating in Rain and wind last night. Haven’t touched it yet. Please made suggestions on how to deal with the aftermath of bullshit Ontario weather.

As far as when to water is concerned you should wait till the pot is light when picking up. Less is better. I have had a lot of issues due to overwatering.

Seems to be working ok now. With the MH bulb but will try the HPS and see what happens. Also the ballast has a switch that you set from 10-110% power. I had it on 110. Maybe too much?

Ok I will try that. It's currently laying flat and inside the tent. Maybe it's running hot in there.

The cord was hot to the extension cord. So I moved it. Still did it.

Thanks. I actually left the ballast pulled in no bulb so it was running. When I went back down stairs it was still going. Leads me to think that it's the socket. I put the MH bulb back in and put the switch to 50%. Was still running a couple of hours later. Just moved it to 75 and I will know...

I have a 400 watt HPS electronic ballast that powers up and then shuts off after maybe 10 minutes. It has a reset button on it and I don't know if it's the ballast or not. I switched the bulb. Still does it. I took the bulb out completely and it still shuts off so it must the ballast right? Any...

Ok I get that. I have the dehumidifier on the room. But if you're trying clone in water then what? The stems become like over cooked asparagus! This has been going on for months now. I get the little bit of what looks like green/blue mould. Doesn't seem to matter what I try. Maybe I will bring...