licoricetree
Well-Known Member
https://www.rollitup.org/t/hlg-c-driver-selection-tool.933565/
Check this out this will help you alot. With what is compatible in series
Check this out this will help you alot. With what is compatible in series
320watts. 4x vero29
- Thread starter laldibap
- Start date
licoricetree
Well-Known Member
Green is good to go
licoricetree
Well-Known Member
Thought my 240 1750 would drive four but nope only 3
JavaCo
Well-Known Member
You can run them at lower currents, they will put out more lumens per a watt running them lower. If you look at the data sheet on them they show lumen output at different currents for all the chips. Running more cobs at a lower current makes for a more efficient light.
Closet-Gardenholic
Well-Known Member
I'm running mine @1400. It will result in 50w instead of 76w. Not as bright, but not as hot either
licoricetree
Well-Known Member
ok now im confused so it looks like if it is a gen6 vero 29 the min voltage for a 1750 driver looks to be 35v area from this data sheet
Jimmyclone42
Well-Known Member
I want to run 5 on a hlg320-1400.... Ive read people running 4.. This calculator says i can only run 3 on a 240???? I thinkbthe calculator is a little wonky
licoricetree
Well-Known Member
ill be finding out if 4x gen 6 will run on a 240 1750a on Wednesday
Budget Buds
Well-Known Member
Arctic alpine 64+ would keep em cool, It's not that hard to wire up the fans, Run in parallel @ 12v with 1amp "driver" and call em good. Get a dimable driver for the cobs, I'm glad I did when I built my light last month. Here is a link to my build thread , it might help ya a little bit 
BB
https://www.rollitup.org/t/vero-29-x-4-cob-build.929757/#post-13307426
BB https://www.rollitup.org/t/vero-29-x-4-cob-build.929757/#post-13307426
nice one budget ! most likely im going with the same tech. my closet is also around 60x60 cm- its higher tho , almost 2m.Arctic alpine 64+ would keep em cool, It's not that hard to wire up the fans, Run in parallel @ 12v with 1amp "driver" and call em good. Get a dimable driver for the cobs, I'm glad I did when I built my light last month. Here is a link to my build thread , it might help ya a little bit
https://www.rollitup.org/t/vero-29-x-4-cob-build.929757/#post-13307426
hows the temps in your tent at full power ? which exhauster are you using ?
cheers
Budget Buds
Well-Known Member
At full power it only gets about 75 degrees f in the tent, I'm just using a small 4 inch computer fan driven at 500 mah to pull air out of the tent and a vent at the bottom opened to draw it in.
sweet ! sounds great
thanks for the info
JavaCo
Well-Known Member
ModuLED Mega 13450 Will go about 37 c above ambient ModuLED Mega 134100 would be about 29C above ambient The ModuLED Mega 13420 is 52C above when all are loaded with 40 watts of heat. Not for sure what efficiency the Vero29 is driven @ 2.1 I would say high 40's at least. Here is the thermal chart.
JavaCo
Well-Known Member
They say it can handle 70 to 80 watts of heat. I wouldn't buy it just because there is no thermal resistance rating. Also costs more
Have you tried Digikey for vero 29 SE?
Jimmyclone42
Well-Known Member
Rapid led is cheaper and you know forsure they are legit..