Ghost0696
Well-Known Member
just put a diy aero cloner thought id share some tips to make it easier on you
1. when buying the holesaw, get a 1.75" so you dont need netpots to keep the inserts up. It holds the m up without pinching, plus it leaves room to clean the edge up with a reamer
2.when drilling your holes for the inserts run the drill in reverse and the bit wont bite into the plastic jerking your wrist and breaking the lid, instead it melts right through.
1. when buying the holesaw, get a 1.75" so you dont need netpots to keep the inserts up. It holds the m up without pinching, plus it leaves room to clean the edge up with a reamer
2.when drilling your holes for the inserts run the drill in reverse and the bit wont bite into the plastic jerking your wrist and breaking the lid, instead it melts right through.