Attaching the Ideal 50-2303CR to the 50-2300AN

I apologize if this has been posted somewhere, I have scoured this forum and the rest of the internet trying to figure out how these two pieces fit together for assembly but I can't find the answer.

I found this video but they are using different reflector holders:

https://www.rollitup.org/t/lens-and-reflector-optics-for-cob.893660/

This page from kingbrite has images that show the 2300AN on top of the 2303CR (attached):

http://kingbriteled.en.alibaba.com/product/60260406625-801593356/Ideal_50_2300AN_LED_connector_for_CREE_CXA3590_CXB3590.html

I have M3 screws for attaching the holder to my heatsink. Do I use the same screws to attach the plastic holder to the metal holder and just go through both at once as pictured on kingbrite's site, or should I attach the 2303CR to my heatsink, then use 2 more screws to fasten the 2300AN as suggested in the youtube installation video?

It looks like four screws hold the two pieces.
http://www.idealind.com/products/oem/led_holders/reflector.jsp

sanjuan said:

It looks like four screws hold the two pieces.
http://www.idealind.com/products/oem/led_holders/reflector.jsp

Click to expand...

I was afraid you'd say that

I'm pretty sure in this video Greengenes mentions that you need 4 screws per cob, 2 per ideal, 2 per reflector:

Yes. The holders require 2 holes, and the adapter requires another 2 hole at I believe a 109* from the holder holes...confirm that in the datat sheet.

Jerry's picture is wrong. And unfortunately has misled many people to thinking it only needs 2 holes. But the data sheets show the correct way and how to do it.

Already posted by @sanjuan above...
http://www.idealind.com/media/pdfs/products/specsheets/Reflector_Adaptor_SpecSheet.pdf

Thanks for the reply @Greengenes707, appreciate it man - got one half of my light all drilled and really to install cobs - will post progress pics soon.

Just posted some progress pics over in my build thread, thanks for the help @Greengenes707

https://www.rollitup.org/t/best-led-for-a-2x4x5-tent-looking-to-replace-a-144x5-mars-hydro-reflector.896220/page-3#post-12279100

I installed mine incorrectly it looks like. But I don't see how this is making it so I can't turn the angelina reflector onto it? Cause even in the correct position, the heights are all the same, but my reflector keeps hitting the plastic Chip-Lok wire inlets. It's pissing me off so bad. I just ordered M3x12&14mm screws both, so I can give the adapter some room. Currently trying to use 8mm M3's and it's just too short. Presses the adapter in to far before it threads. I think that's my real problem. But where the side of the adapter near the screw hole is cut straight off, it almost seems that's the way they SHOULD BE installed?