Cloning Made Easy!!!

Marlowe

Marlowe

Active Member
View attachment 1022440

I start with these four moms (2 skunk #1 and 2 the pure)...

View attachment 1022441

I use rapid rooters ,clonex ,straight razors and my bud trimmers

View attachment 1022444

First pour a little clonex into the lid and set the bottle aside... Next stick your scissors edge down into the rr's... this ensures later you won't have a problem jabbing your clones into them (sometimes they only go down about a 1/2'')

View attachment 1022436

Remove a branch about 6 to 8" long

View attachment 1022442

Here you can see I have removed the bottom two branches and made a 45 degree cut about a half inch below those removed branches...

View attachment 1022437

When dippin in the clonex just make sure bottom inch gets covered and no need for exess...

View attachment 1022439

Then just stick in the rr... push it all the way through and pull it back up about a 1/2" ...

View attachment 1022438

Use your scissors to trim off leaf edges... this focuses energy back into creating roots...

View attachment 1022443

Then place in tray and cover with dome...

005.jpg

For the first week finely mist dome once a day (not plants)... after a week take dome off and then mist plants once a day... at two weeks you should have roots!!!
 
Marlowe

Marlowe

Active Member
Thanx glad you like it... this system has always brought me above 90 percent sucess rate...
 
thatdjsnow

thatdjsnow

Well-Known Member
true that... there are some people on here that make things entirely too difficult... forgetting they are just weeds.

I made a crappy 15 site bubble cloner for under $20 and have had 100% success rate so far on over 30 clones.... well, except for the one who's stem was sticking OUTSIDE the back of the lid when I closed it... and didn't notice until the next day. :P nice crispy little pile haha
 
You must log in or register to reply here.
Top