i just all the leds and the driver which runs at 320ma the leds are rated for 350ma. i went and bought resistors but not sure how much i need. the voltage from the driver is 136 volts. the volts are suppose to run at 3.2 volts. the resistors are rated for 1/2 watt. this website should help anyone out if they so need it http://www.hebeiltd.com.cn/?p=zz.led.resistor.calculator. i am no where near an electrician. can someone please help me
just got all my leds in the mail but i keep blowing them HELP!!!!!!!!!
- Thread starter music64
- Start date
guod
Well-Known Member
normally you need no resitors on constant current drivers.
on this drivers you will see two values for the output-voltage.
this is the range where your driver works properly.
example:
output:
30-80 VDC
350mA
minmum Leds for this Driver(white ones)
30V/3.2V=9.37.. ten white leds will be the minimum
the maxium white leds you can drive is
80V/3.2V=25.. i would go here for 24 white leds for some safety.
on this drivers you will see two values for the output-voltage.
this is the range where your driver works properly.
example:
output:
30-80 VDC
350mA
minmum Leds for this Driver(white ones)
30V/3.2V=9.37.. ten white leds will be the minimum
the maxium white leds you can drive is
80V/3.2V=25.. i would go here for 24 white leds for some safety.