Cydraalv
Member
Find any cooler taller than 15 inches
Open the lid.
Cut the bottom of the lid out on the inside of the dropped lip.
Drill holes every two inches in the bottom of the lip.
I use Aqua Via water pumps as they are low heat and only $16 for a 315 gph
Depending on size of cooler you should only need one pump.
Make a PVC manifold that sits as a flat square (or circle in a water cooler).
Drill and Tap the top of your manifold for a pack of EZ Clone 360 nozzles.
Drill 1-7/8" holes where you want to put your donuts (not sure what they are called) I use the harder thicker 2" foam ones as they seal tighter. run power cord through a donut, dump your juice in and never worry about waterproofing : >-~
Open the lid.
Cut the bottom of the lid out on the inside of the dropped lip.
Drill holes every two inches in the bottom of the lip.
I use Aqua Via water pumps as they are low heat and only $16 for a 315 gph
Depending on size of cooler you should only need one pump.
Make a PVC manifold that sits as a flat square (or circle in a water cooler).
Drill and Tap the top of your manifold for a pack of EZ Clone 360 nozzles.
Drill 1-7/8" holes where you want to put your donuts (not sure what they are called) I use the harder thicker 2" foam ones as they seal tighter. run power cord through a donut, dump your juice in and never worry about waterproofing : >-~