Power cord for HLG drivers

Hello!

I'm looking for a power cord for my Mean Well HLG drivers. I'm from Europe so my plug should be something like this one:



I found this one on mouser:
http://mouser.com/ProductDetail/Qualtek/363012-D01/
Can anyone confirm if this is the right power cord?

Thanks in advance!

if it fits in your wall its the proper cord, the meanwells dont need any cord in particular

I've been using old pc / monitor power cords, good for 10a, some say 15a. Clip the end and solder to the driver leads.

I've just taken a 3 pin plug from an old computer. Lopped the end at the size I needed it to be. And attached it with some screw in electrical connections.

I do need to find a better alternative though. Its ugly and clunky.

Just make sure you put the wires on the right way. 120-240v goes bang somewhat violently at times. And can kill or severely damage you.

get an appliance cord form your local hardware store and just replace the cord using wagos.

You can get a pretty clean look with solder and shrink tube, I use three small pieces for the individual wires, one larger piece to fill the gap where the original insulation was removed, then one more large piece to cover everything.