Recent content by zero1776

I bought a Toshiba 36,000 Btu unit through a friend of mine that does hvac for a living and have not been able to get him out hee after i installed it to pressure test vacuum it down and release the refrigerant. So i would advise to get one you don't need a hvac guy out to get it started...

Got a few of these going to try them out

Has anyone tried the cool tubes that run through a hood?

Guess it worked old light mover pic 20ft wide holds 5 hoods.

don't know if this will show up..

Looks like i will be changing hoods and going with the max tube expanded 24". Which is 31.5" long cool tube and has a hood. I will be converting them over to hold 2 bulbs. The width and better air flow is why i will make the change.

I was thinking about cooling the exhaust air from the hoods with a water chilled heat exchanger to help with heat signature.

Using CO2 generator which will also produce heat when the burners are on.

I have a 36,000 Btu mini split to cool the room would it cool enough for no air cooling on the lights? I do appreciate the help thanx. Intake temps are 70°F at most.

Any advice on where to fey help on this issue?

I'm looking for a solution that is not exchanging the air in the room . I want to draw air in from an external source in through ducting through sealed hoods out of hoods back into ducting through a wall and out a fan that is sucking air through all of this. Most people are talking...

The other fan option is a 2905cfm 14 in fan and ducting.

How many cfm's do i need to cool 600w hps? I plan on running 12 inch inlet ducting then split it to the hoods on the light bar using 6 inch ducting. Then the same on the exhaust multiple six inch ducts to the 12 in to a 2050 cfm fan pulling air. The inlet will have a air filter all air will...

No hits on this just lots of lookers. I will wait to post pics until the mold is complete so I can show the finished product. And then get some feed back on what you guys think. And maybe a redesign if I get better ideas from the group. The mold should be done this week so hopefully a couple of...

I was in the process of building a media free plant support for the aeroflo units you would be able to use them in custom units as well. I was wondering if there would be a market to sell them? If I get enough feed back for them I may produce them. I would need to know what people...