Driver and cob/holder matching question

So I'm looking to power 3 x cxm22 chips they are 50v and can use the same accessories as the clu-048 chips.

What I'm looking to do is use the 150v bjb holders with these cobs and use a mean Well hlg-120-48a, since I'll be at or slightly under the max 150v rating on the holders can I use them in series for 3 of these chips per driver?

Will save a bit of cash since I'm planning to do more then just these 3, with 3 per driver if this is safe?

@CobKits @welight @Growmau5 and anyone else that could chime in,

Thanks everyone !!

ive personally used the bjbs up over 200V but cant endorse that for obvious reasons

if its a big concern for you just use ideals

Doesn't the voltage rating refer to the amount being applied to the chip, that is, 50 volts? Or, are you saying each cob holder has to be rated for the entire string of say, 200V? That doesn't sound right, but I'm here to learn. Also, that driver is for parallel wiring, isn't it?

CobKits said:

ive personally used the bjbs up over 200V but cant endorse that for obvious reasons

if its a big concern for you just use ideals

Click to expand...

Okay ty and can these drivers be used in series or are they meant for parallel installations?