Recent content by pedrovski

Just thought i would leave this here and hopefully some of you guys can make use of it. With living somewhere with thin walls i needed an alternative to an air pump and never found one that was powerful and quiet so found an alternative that works better. A water trickle and the small hum...

I would personally add silica first. It Does not like staying in solution so adding it to your water first means less chance of precipitation. So silica, main nutes, cal mag. Then of course whatever your using to ph.

Hi, When i used mainlining it took about 4 weeks to get 8 colas to about 2 ft in Coco before i flipped to flower. Although in my experience it isn't as effective as a scrog it gets a much better yield than just having a tree and doesn't require as much effort as a scrog so it certainly has its...

By decreasing the temps what kind of temps do you currently have? I know Anything consistently above 28 degrees c can decrease the overall amount of thc your getting at harvest so I keep my temps between 20-27 degrees day and night. No need to go out of that range.

This lighting schedule mentioned a little earlier in the thread

Using a one of the sonoff wifi timers make all these custom light schedules super easy to set up. I do however have a question about this glt schedule. Ive got 730nm leds in a tent with 3500k 90cri citizen cobs that i would generally run for 10 mins on lights out on a 12-12. Any suggestions...

Im in the uk and ive used these Heatsinks with no issue at 50w passive with general air circulation...

The quantum boards are superior to hps in every possible way apart from the initial cost being higher. The individual diodes making up the 150w panels means a better spread of the light so therefore better penetration of the canopy. The idea that led doesn't penetrate the canopy as much as hps...

I'm in the uk and just built myself a 300w panel using clu48-1216 3500k 90 cri leds at around a tenner each bought from Kingbright on alibaba. These are being run at 50w each and are far better than the 3w epistar leds and would not recommend the 3w diodes as they are pretty inefficient. I...

Currently using cxa3070 leds I've had for a couple of years Looking for an upgrade at roughly 300w. for 6x clu48-1216 3500k 90 cri leds, Heatsinks, drivers & shipping looking at $280. For 2x qb288 boards a HLG-320-54 and shipping about $320. From peoples experience would this be worth...

Currently running 3500k 80 cri cxb3070s with 10 mins of 730nm at lights out for the 'flower initiator' to which i have noticed strains finishing maybe a week earlier. Next step is a bigger setup using clu48-1216 3500k 90 cri leds as I have seen good results using the 90 cris which on its own...

I can personally confirm Too much ozone will damage your plants, I have experienced this from leaving one on for too long. I would suspect with high doses of ozone damaging the leaves this would reduce photosynthesis so i don't think that type of stress would be good. Ozone is best used in...

Calcium is an immobile nutrient so lots is needed during the stretch and bud formation but tapers of after the bud has filled out so if your Base nutes have enough in then your probably dont need it after week 6-7. Calcium also isn't likely to be the cause of a harsh smoke with it being an...

The conclusion that just 660nm and 450nm leds is needed is very outdated check out pretty much any thread In the led section and you'll see that You need full spectrum leds generally people stick to around 3500k to get the plants to there full potential it's not just the chlorophyll a and b...