hey, i picked up a cooltube with that has a built in socket for the bulb with b/w wires comin out the back bare. The ballast i got with it has a socket attached to the end of its output already too, so do i need to splice the cable before its socket and wire it to the one already on the cooltube? note the one already attached will not mount properly in the cooltube.
also 2nd part to do with voltage, the ballast says 240v on it with marker, but has a 3 prong 120 volt looking plug on it. The manufacturer writing on it says 120v, but then has a chart showing that 240v = 4.5 amps/120v=9.5 amps or something close to that, i asked them to wire it to 240v for me at the store, but i thought that had a 4 prong outlet to it... someone please clear me up on this, thanks
also 2nd part to do with voltage, the ballast says 240v on it with marker, but has a 3 prong 120 volt looking plug on it. The manufacturer writing on it says 120v, but then has a chart showing that 240v = 4.5 amps/120v=9.5 amps or something close to that, i asked them to wire it to 240v for me at the store, but i thought that had a 4 prong outlet to it... someone please clear me up on this, thanks