Recent content by synthox

I was planning on folding them back and using a generous amount of electrical tape. Thank you for your help!

I am planning on using wiring twist caps and wiring the boards like the pic below. Is this correct?

I am looking to power two QB288 V2 Rspec boards with the following driver. Is the power cord pictured adequate for the task? If the plug is adequate, my next question is, how should I wire it? Left is the plug right is the driver.

Here is a pic of what I am talking about. One of my optic strips survived, sorta, I don't wanna pull it off fearing more damage.. The flowers this board is producing are looking fair, all things considered

My ex-wife chucked the board across the room and damaged it. (Note ex). 266 diodes are still working just fine. I have used the board for about three months now. I have been running it at full power to compensate for the missing lights.

Are you asking if I have a heatsink? I do. I have one that came with it as a kit. Should I turn the voltage down?

I have a 304 board that suffered some damage and one strip of the leds does not work. I have it as the only light flowering a 2x2. I am running it max voltage and it is doing well. Should I turn it down? If so, how much?

I have a small indoor garden. I have just started the flowering and I have males with a female in a grow tent. Would anyone be so kind as to link me a thread where it discusses harvesting and preserving pollen sacs while not ruining bud production? My overall goal is to harvest the pollen...

I bought a QB 304 a bit over a year ago. I only used it for about two weeks. My ex-wife broke a whole strip of the diodes so only 266 of the diodes function. Enough to flower a 2x2x4 tent?