the gh nutes used on cuttting/ seedling ratio have so far been working great i basically took a look at two bubbler cloners found a small well sealed pop on lid container put a small heater in it 25w and add a grommet through the side for an air line in and attached a air stone cut out a tiny bit of plastic in the corner for the heater cord cut slits in the lid and then cut 1inch thich foam strips just bigger than the slits so theyd fit snug i then cut slits even spaced in the foam to let me slide the cutting in easily but not to tight to choke it i offset each row so the cuttings had abit more space i also tried using a combo of honey and powder rooting hormone i mixed in a small amount and then stirred it . other than that i did everything as normal . cut the cutting , put in under water and made a new cut on a 45 degree angle about 5 mil below a node and then pull it out of the water shake it off a little and dip in the honey mix ( usually clonex gel but lack of money ) and the slid it in the foam strip to an even depth , repeat it until its full and then stick the lid with cutting in it on the tub level on nute was about 15 mil at first but i found it was getting them to wet they dripping constantly so i dropped it a couple of inches and its perfect theyre healthy as and despite the fact they sat inside under no light but my bedroom incandesant and theyre rooting in 8-9 days . the worst the cutting eg the ones at that are tiny and weak looking are the fastest i heard that its better taking from the bottom of the plant but it has never been the case for me before where ive used rockwool cubes clonex gel and mini flood and drain clone system .the bigger and healthier the cutting the faster theyd root yet here the cuttings i almost threw out but decided it was a test of the bubbler and may as well give it a go have been the quickest.