Try vinegar and water. Vinegar will smell so make sure you wash it out with soap afterwards. 420 solution>??
91% iso in the nuke? i dont know if thats such a good idea,, after all it is flammablejust heat up some 91% rubbing alcohol in the microwave and swish it around. Water sucks, it doesn't dissolve the resin!
The problem with all these solutions so far is, they make your piece taste like alcohol or salt for a while. Use 420 Cleaner, by far the best, the all natural works best
rubbing alcohol, never tried the epsom salt, just regular table salt but it takes that shit right off. might take a little time and elbow grease but itll sparkle once again
It's fine, alcohol has a lower boiling point than water, put it in the microwave for 20 seconds and it will be fine... plus there's no open flame91% iso in the nuke? i dont know if thats such a good idea,, after all it is flammable
straight up isopropyl alcohol (99%) works best because it is the tar you want to remove and that tar that is not water soluble so you need a solvent to remove it.. iso just happens to be to most easily accessible liquid solvent with a relatively low evaporation point and with no impurities other than 1% water.
420 Solution is the best IMO, has a good smell to it too