meangreengrowinmachine

Well-Known Member
Not that I could not figure it out with some trial and error but figure maybe if you have already done that you could pass it on lol. Its cool if not, at this point 90% of the shit i fix i just grab what I have i some random place and be like oh this will work if I rig it with this and this that I have... where as if I had the actual right parts it would be much different lol
 

MICHI-CAN

Well-Known Member
I'm back. The materials i used are 3/4" I.D. X 1.00" O.D. food grade tubing , 3 x 1.25" hose clamps and a 90 degree stainless elbow for HVAC or radiator use. I am replacing with a 90 pvc hose barb as it is a better fit and will not kink the hose on the outside or restict inside without housing mods. I'll post this when I do it.
 
Last edited:

meangreengrowinmachine

Well-Known Member
I'm back. The materials i used are 3/4" I.D. X 1.00" O.D. food grade tubing , 3 x 1.25" hose clamps and a 90 degree stainless elbow for HVAC or radiator use. I am replacing with a 90 pvc hose barb as it is a better fit and will not kink the hose on the outside or restict inside without housing mods. I'll post this when I do it.
Thank you!!!
 

meangreengrowinmachine

Well-Known Member
I'm back. The materials i used are 3/4" I.D. X 1.00" O.D. food grade tubing , 3 x 1.25" hose clamps and a 90 degree stainless elbow for HVAC or radiator use. I am replacing with a 90 pvc hose barb as it is a better fit and will not kink the hose on the outside or restict inside without housing mods. I'll post this when I do it.
What do you think the diameter of the out put water spout is? Looking at barbed pvc 90s now wondering if I need a 1 inch to 3/4 barb?
 
Top