Help! Leaves curling

smoothJoe

Well-Known Member
Temp on the gauge say 20.7c right now but i have it open trying to do my set up thanks bro...and it’s sister* :wink:
ok mom ur temps are 20c so if you up to about 28c ur humidity will drop to about 60% hopefully

sister :) u need a good avy like mine
 

budofgreen

Well-Known Member
Sorry what I’m asking is does the fan blow into the carbon filter? Tryna figure out the correct way to put my fan. Suction is out?
You want the carbon on the suction side of the fan
Al

also once i install How long should i wait To switch to flowering?
That would be up to you personally on when to flower. Get your environment in check first. I would put the filter on the suction side of the fan, so the air is pulled into the filter then out the fan and finally exhausted.
 

2andfly

Active Member
You want the carbon on the suction side of the fan

That would be up to you personally on when to flower. Get your environment in check first. I would put the filter on the suction side of the fan, so the air is pulled into the filter then out the fan and finally exhausted.
Thanks bro you’ve been a ton of help, preciate it a lot !
 

budofgreen

Well-Known Member
Went with this set up, got the fan on the lowest setting
That will be a game changer. Keep an eye on your temp/humidity and keep them in ballpark range and you should be good. If your tent bows in too much open up an air flap at the bottom for some passive intake to the tent. Just keep reading on the subject matter, some of it is just preference. Keep it simple.
 

2andfly

Active Member
That will be a game changer. Keep an eye on your temp/humidity and keep them in ballpark range and you should be good. If your tent bows in too much open up an air flap at the bottom for some passive intake to the tent. Just keep reading on the subject matter, some of it is just preference. Keep it simple.
image.jpg
 

2andfly

Active Member
Well now you are learning some high stress training...:clap:
shit hurt my heart..do i leave One of these open to reduce suction a little? And if humidity is at 44% do i need To put a humidifier in? Or give it time ? Last couple questions and I’ll leave u alone image.jpg
 

becasueracecar09

Active Member
I would take some of the 4" flex duct you have, and put it through the port you show in the picture above, and make it into a U, so no light gets in/out of your tent.

If your humidity is still a little too low, you can add some tape over half of your exhaust duct to reduce the airflow rate even more. I do that in my drying room to reduce airflow and extend my drying time.
 
Top