Hey I am new to the forum and new to the hobby as well. Here is a list of my equipment. I am running an ebb and flow on my main setup which consist of one 4x8' and three 4x4's. I also have an aeroponic 165site cloner, and two shed units that run with a fogger in the res and a drip system on top. The shed units run one air cooled 400w MH each. I have eight 1000w Liquid cooled Liquid Lumens HPS units for flower, and two 8 bulb skinnyBoyzz T5 units for cloning. I have a hannainst TDS/PH/EC portable meter, one CAN160 and one CAN60 scrubber for odor control. I am using a 24500BTU window AC unit with thermostat and dehumidifier built in, and an 11000BTU CO2 burner. The room is about 130-140 sq feet. I am using three oscilating fans and one ceiling fan. I have the best genetics, and I am using clay pebbles as my primary medium. I am germinating the seeds and once a taproot appears I am moving them into the shed units under 400w MH in a rockwool cube until 3 inches tall, at that time I intend to move them into the main ebb and flow system.Some basic questions and sorry if this comes off as noobish or redundant but frankly I am a noob and I would appreciate any input from people more experienced then I. Since I am starting these from seeds how long do I have to veg before I can begin flowering? How long before I can begin cloning? I am using Gen Hydro FloraGro/FloraMicro/FloraBloom along with CalMag, Floralicious Grow, Floralicious Bloom, and Liquid KoolBloom are these great neuts to use? I have already purchased enough to make 1500 gallons but I am still willing to switch if I am told I made a mistake. Also since I have a Co2 burner and the AC unit with dehumidifier do I still need a vent system or do I have to punch holes in my walls? Also keep in mind my lights will be running at about 70F liquid cooled, I plan on starting using three to four of my 1k HPS and then slowly installing the rest. Thank you in advance and I really look forward to hearing from you guys.