Make your own Vaporizer

MrMarine420

MrMarine420

Active Member
I Found this on the net Let me know how it works or other ideas you come up with. And its really really easy to do

There are a lot of really expensive vaporizers available, but there are cheaper ways? This might not work as good as the $200 ones, but it does work well.

Parts list:


Normal light bulb (100 watts if possible; the glass is more heat resistant than 40/60 watters. The bulb should be clear and not frosted)

Knife
Scissors
Tape
2 straws or glass tubes (glass tubes are better since they can't melt)
Cap of a 0.5 liter bottle (US: 16 fl. Ounce bottle cap)

Construction:
First if all, we start off with preparing the buld by cutting off the lower part like this:



You might want to sand off those nasty metal edges since they are really sharp, like this:









Now, in step 2, we need to get the wire and all that out: (Remove them either with a small wrench or break them out with something else like a pair of pliers)



In step three, unscrew the cap of the bottle, and try to fit it on the metal part of the bulb, if it doesn't fit because it's too small, get another cap, it's ok if its too big. Now take a knife and make two holes into the cap, like this:








Now we have to make the straws the right size, take the scissors. If you are using glasstubes, take a wrench to break them at the right point, and take fine sand paper to make the edges smooth.


If the cap is a bit too big, just take the tape and fix it. Even though its easy to do this, every time you want to fill or empty it you have to tape it again. So try to get a cap that fits! There is another way you can tape it, like this, that's easier:








Before you use it for the first time take cold water and wrinse it out, glass and dust might be left inside, and you don't want that in your lungs....DONE!

To use it, unscrew the cap, put whatever you want to smoke inside (careful, you don't need as much as you need in a normal joint), take a lighter or candle and heat it, inhale, and when you taste something, its working.
Don't wait until it smokes, because that will leave stains. In the best case, you will take out the weed, for example, looking just like you put it in, but smelling like hay after you are done.

Here is a version with one glasstube instead of a straw, and how it actually looks when being used. Thanks DoobieScoo.
 
You must log in or register to reply here.
Top