MrMarine420
Active Member
There are a lot of really expensive vaporizers available, but there are cheaper ways? This might not work as good as the $200 ones, but it does work well.
Parts list:
Normal light bulb (100 watts if possible; the glass is more heat resistant than 40/60 watters. The bulb should be clear and not frosted)
Knife
Scissors
Tape
2 straws or glass tubes (glass tubes are better since they can't melt)
Cap of a 0.5 liter bottle (US: 16 fl. Ounce bottle cap)
Construction:
First if all, we start off with preparing the buld by cutting off the lower part like this:
Now, in step 2, we need to get the wire and all that out: (Remove them either with a small wrench or break them out with something else like a pair of pliers)
Now we have to make the straws the right size, take the scissors. If you are using glasstubes, take a wrench to break them at the right point, and take fine sand paper to make the edges smooth.
To use it, unscrew the cap, put whatever you want to smoke inside (careful, you don't need as much as you need in a normal joint), take a lighter or candle and heat it, inhale, and when you taste something, its working.
Don't wait until it smokes, because that will leave stains. In the best case, you will take out the weed, for example, looking just like you put it in, but smelling like hay after you are done.