Mars Hydro Grow Journal-TS1000-Glueberry Muffins by Destiny Exotic Genetics/2.3x2.3x5.2ft tent.... With a Twist.

Long story short. I dried the Cup clone in a small tent. Maintaining 65% humidity and about 68F. Being the buds are so small on the plant (Basically popcorn & tops) I didn't expect it to take long to dry, but it did take 7 days.
When I removed the buds and weighed them I got a whole 13g lol.

Using a wireless Inkbird Hygrometer in the jar to keep track of Temp/RH.

1/15
Just some green

1/17
She's getting a little out of hand again with the thick foliage.

Under shots after the trim

Over the next few weeks it’s just going to be more LST, and trying to keep her canopy even. If something shoots up, gotta make sure I tie it down. Also chopping of the cloth potted clone coming up.

Let me not forget to show you guys all the foliage that bit the dust.

Tired of this here..
I'm actually going to start ph'ing with my nutes. The Advanced nutes get me in the range I need every time just about. If it's off by a couple of points I don't sweat it. The soil can buffer the ph.

How do you add your pH down hydro?... Do you dilute it first? I used to have a nightmare because I used to add it straight to the water/feed became loads easier to adjust once I started diluting it first... I use a pin and each droplet off the pin equals 0.1 point on the pH pen every time but even so I hate using it... Horrible corrosive stuff!

HydroKid239 said:

View attachment 4823967

Click to expand...

So healthy looking

Blaze187 said:

How do you add your pH down hydro?... Do you dilute it first? I used to have a nightmare because I used to add it straight to the water/feed became loads easier to adjust once I started diluting it first... I use a pin and each droplet off the pin equals 0.1 point on the pH pen every time but even so I hate using it... Horrible corrosive stuff!

Click to expand...

When I was using it, I would add all my nutes first, then adjust to 6.5 or closest I can get. Sometimes if PH landed at 6.2-6.3 I'd leave it there.
Now I let it ride wherever it sits. During each cycle the nutrients change, and thus the ph changes. I try to stay within 5.9-7.1 without swinging more than a couple points in either direction from the last feed I'm good. When you feed a PH of 6 for 2 weeks, and then switch up to a flat 7 the week after.. I think that's how you cause issues. Not 100% sure. I'll do an experiment in the future and find out for sure if that does cause issues.

I don't think that monster is bothered by the pH much anyhow.. its looking lush!

HydroKid239 said:

Tired of this here..
View attachment 4824800 I'm actually going to start ph'ing with my nutes. The Advanced nutes get me in the range I need every time just about. If it's off by a couple of points I don't sweat it. The soil can buffer the ph.

Click to expand...

Do you use 25% strength phosphoric acid? Cheers!

Wastei said:

Do you use 25% strength phosphoric acid? Cheers!

Click to expand...

Honestly I have no clue exactly what it is. Ordered on ebay and tested it. Works good... sometimes too good when using small amounts of water. It became a big hassle when watering solo cups, and having to mix an entire gallon to get it right. I haven't used any PH liquids in weeks now. Don't miss it. Maybe I can clean my rims with it? lol

HydroKid239 said:

Honestly I have no clue exactly what it is. Ordered on ebay and tested it. Works good... sometimes too good when using small amounts of water. It became a big hassle when watering solo cups, and having to mix an entire gallon to get it right. I haven't used any PH liquids in weeks now. Don't miss it. Maybe I can clean my rims with it? lol

Click to expand...

Try diluting down to 20-25%, way easier to use. A dosing syringe makes dosing and diluting down way easier when working with smaller volumes.