concrete351
Well-Known Member
ok let say i have a 8 gallon rez at 6.0 and i want to adjust to 5.5 and so i adjust it, then when i test it and it reads 4.0 can i keep adjusting it until i get to 5.5?
PH Question
- Thread starter concrete351
- Start date
SlickRickMcgee
Well-Known Member
ok let say i have a 8 gallon rez at 6.0 and i want to adjust to 5.5 and so i adjust it, then when i test it and it reads 4.0 can i keep adjusting it until i get to 5.5?
Yeah, happened to me plenty of times. I put too much PH down in the rez. Just pour some tap water in it a lil bit at a time and then re-test it incrementally till it's where you want it to be.
concrete351
Well-Known Member
? dont want to change my water level but i guess it all the same? won't hurt the plants?
mofizzle415
Active Member
Yeah bro and your also gonna notice that in a small reservoir your PH is gonna chnage every 2-3 days...usually going up...5.7-5.8 is perfect for all nutrient uptake...keep adjusting till you get it where you want it...
concrete351
Well-Known Member
so adjusting it at rez change more then .5 will not hurt the plants but just when the ph is running constituency for a couple of days!?
SlickRickMcgee
Well-Known Member
From my experience, your ph will line itself out after a few days. Don't get upset if it's a lil too high or low. Shouldn't affect a healthy plant. Your on it and aware of checkin it, so you should be good. Just keep it consistant if anything. Too much more than 1 point one way or the other is negative IMO.
concrete351
Well-Known Member
ya i have the other problem going to high and adjusting down
was thinking if ppl have stress by ajusting 1 point within mins of rez change
exsample
rez change ph 6.0
5 min later 7.0
adjust to 6.0
10 min later 7.0
adjust back to 6.0 ect........?
was thinking if ppl have stress by ajusting 1 point within mins of rez change
exsample
rez change ph 6.0
5 min later 7.0
adjust to 6.0
10 min later 7.0
adjust back to 6.0 ect........?
