RDWC room

Am I missing anything for wiring, or is there someone that has built a room with this style system in mind?
I am trying to have all my basis covered, just do t want to miss the boat on something easy.
So I am wired for multiple fans from every corner, humidity up and down sensors that will run to humidity and dehumanizing units, heater/ac, winch to raise and lower my scrog, anyone have any last thoughts on a good idea to wire while I have this ceiling open? Or do I have it covered? Any help would be great

Once I put my sites together, ceiling access was tough, things I took note to change this time would include, using clamps on ducts not foil hvac tape. Install extra hooks and mounts in various spots in the ceiling, white paint over wall reflective covering. Not big stuff.. I installed a oscillating pedestal fan upside down from the roof in flower, that would of been better at a corner I couldn’t reach. Plugging in fans and securing the cords high and out of reach was a bad idea. Post some more pics, you have the RDWC system figured you are just wondering about the room?

J232 said:

Once I put my sites together, ceiling access was tough, things I took note to change this time would include, using clamps on ducts not foil hvac tape. Install extra hooks and mounts in various spots in the ceiling, white paint over wall reflective covering. Not big stuff.. I installed a oscillating pedestal fan upside down from the roof in flower, that would of been better at a corner I couldn’t reach. Plugging in fans and securing the cords high and out of reach was a bad idea. Post some more pics, you have the RDWC system figured you are just wondering about the room?

Click to expand...

I think I have the RDWC the way it should be, I am planning on using a waterfall system, good call on the ducks, I will pick up regular ducting versus the foil shit, I have an outlet to the garage in foil, just to allow fresh air into the area and was planning on using the fan where my filter is now and vide versa, I will shoot you some more pics, sorry about the mess it is midst construction . The last photo is where I was planning to put my res with a drain straight to the drain, and move water to my site when required from my water supply with a valve.
The second will be kind of my control center I guess?

I have also got reflective foil I will be putting on the walls when I’m done, however I think for what it takes after I am done ceiling my joints I will throw a coat of white paint on, I was going to do the floor so the extra step is just great and won’t have to do it in the future if needed

I will probably get a final verification on the flow before I do that portion though to make sure I got it correct

Looks good, as long as you have extra hooks up high and plugins, should be good.

I was thinking of running 3 1.5” pvc tubes on ratchet straps or solid to handle anything I want to hang rather then using the roof, then you have the movement of just sliding hangers down the tube and not anchor points on the roof.

J232 said:

I was thinking of running 3 1.5” pvc tubes on ratchet straps or solid to handle anything I want to hang rather then using the roof, then you have the movement of just sliding hangers down the tube and not anchor points on the roof.

Click to expand...

3 - 1.5 inch or like 3 inch?

Hippieryan said:

3 - 1.5 inch or like 3 inch?

Click to expand...

Like 3 x 5ft 1.5” pvc tubes, like rails. I have higher ceilings as well, figured it would be a good rack for multipurpose hanging. Seen guys hanging led racks off tubes on ratchet hangers.