Seven Sisters

Flatrate

Well-Known Member
Good luck Tint! I hear ya man on the learning experience, one of mine I never really talked about was 9 plants in 3 gal pot that I chopped in the end of January. I was pissed and scrapped it, all got made into wax.
 

DoubleAtotheRON

Well-Known Member
@Flatrate Wish me luck. Last run was a learning experience of the negative type. Lol

New light setup.
View attachment 4863568

View attachment 4863569
All Cobs 280w.
All Strips 280w.
Dimmable.


Not jealous of your new smoker. :lol:
Im wondering when this gathering of BBQ, smoke and beer is gonna happen.... Don't worry @Flatrate , we'll give you a min to get used to the new equipment..... If you need it hauled to Oklahoma within 24 hours, Im your man. Where's the Snowman?.. gonna need a truck.
 

TintEastwood

Well-Known Member
I use. Coarse coco.
20210401_185140.jpg

F the Fine coco.
20210401_185333.jpg



Below. Never.again. Gold label coco. (I added the perlite.)

It's weird.
Wet or dry, this coco is noticeably black vs brown. Out of the bag, no perlite, retains way too much water. Probably contains lots of fines and dust.
Choking out my starter plants.

20210401_185219.jpg

Perlite rinsing out the powder and dusty crap.
20210401_185555.jpg

For bottom of fabrics. Optional.
20210401_185757.jpg
 
Last edited:

TintEastwood

Well-Known Member
Goggled up some ammonical techno references to read.


 

Buck5050

Well-Known Member
I just started using Jacks myself and been mixing with 15ppm RO exactly 321 with no extra additives and I end up at 1.8 EC. It seems a little high to me but wasn't sure what everyone else is getting. Are your EC readings on the above chart correlateing with what you're getting after you mix up a batch?
 

TintEastwood

Well-Known Member
I just started using Jacks myself and been mixing with 15ppm RO exactly 321 with no extra additives and I end up at 1.8 EC. It seems a little high to me but wasn't sure what everyone else is getting. Are your EC readings on the above chart correlateing with what you're getting after you mix up a batch?
My final mixed EC is always higher on my meter(s) than advertised.

It used to drive me nuts. Lol

It's my understanding that it's related to some non-nutrient dissolved solids in solution.

I feed between 1.2 and 2.0, on the meter. Often 1.7ish.
 

Buck5050

Well-Known Member
Yeah it's a little mind-boggling when all that was added in was the nutrients to begin with. I start tripping on my meter and wondering if it's off even after calibration or some other factor I'm not considering.
 
Top