unrooted clone leaves and stem yellowing!

Light House

Active Member
I'm going to assume they were taken at a 45 degree with a clean cutting edge.

Then I will assume the plants were dipped into a cloning solution.

Good news I have had clones take two weeks from some slow strains. Bad news algae sucks however most clones can grow through it can cause moisture lock.

Look at damping off and think about adding some drops of 29% peroxide to water. Heat mat will speedy things up. And just to make sure they don't need a lot of light.
 

arrozkongandulez

Active Member
I'm going to assume they were taken at a 45 degree with a clean cutting edge.

Then I will assume the plants were dipped into a cloning solution.

Good news I have had clones take two weeks from some slow strains. Bad news algae sucks however most clones can grow through it can cause moisture lock.

Look at damping off and think about adding some drops of 29% peroxide to water. Heat mat will speedy things up. And just to make sure they don't need a lot of light.
im a little confused.... yes they were cut at a 45 degree angle dipped in rootech cloning gel, i believe i split the stem on this one a bit.... the clones are under a bit of light (300W cfl) because i need them for warmth.

the strain i took the cutting from is DinaFem Blue Widow... its an indica dominant so i thought it would be easy to clone...
 
Top