Voidlings First Cab

Too big?

I did a fogger for my clones for a while, but my disks wore out. I need to figure out online ordering. They're cheap online, and I dunno even where to look for just the disks(not the unit) locally.

Have you seen the foggers used in car engines? Pretty cool, they fog the fuel and pump it in to the intake.. Crazy mileage boosts too.

I could fit more 2 in for sog. Looking at how small this flowered clone is going to be. Going to need to veg them. Perpetual will be out the window I think.

Also, hadn't seen that before. Seems like a bad idea though.

Check this out.

http://youtu.be/l37U7D8AnwU

ha I hadn't seen that. The one I saw was a guy dropping a fogger into the gasoline on an old carburetor engine.

Does your fogger also splash up water along with the fog? This one is. If I had spent $50 on the thing as a fountain fogger I'd be disapointed in the fog it creates. The float it comes with is so large it'd be quite obvious in a fountain if not take up all the room, and produces minor amounts of fog for it. Need to figure out how to cover up the lights

Turns out my timer on my flower lights wasn't working properly. It went off as I was sitting here in the middle of it's day cycle.

Day 1 coffee can fogger cloner test

Yeah they push water too.. Be careful about putting your fingers in the vibration zone above the disk, I got a knuckle too close and the ultrasonic vibrations hurt my finger joint for two days!

There is a certain depth below surface where it makes the most fog(mine don't have floats,so I can adjust levels by putting blocks under it)

Yeah it came with a float. You forgot to mention how much they heat water.it is warm. Ha

Really digging this song
https://www.youtube.com/watch?v=ZG7ATg1WAvY&feature=youtube_gdata_player

Good song. Nice setup they got there too

Even the big pump can't power the fogger misters

The screws on the mechanical timer are recessed so far I can't get the bit to it to modify the thing

The water was awfully warm. It wouldn't be a problem if it wasn't spraying up drops onto the roots. I dumped some ice into the container and put it on a 15/15 timer. Hopefully that helps. Would of liked shorter but my timer mod didn't work.

I turned my fan and filter back on. Same strange smell. I really need to replace it. Need to get a cycle timer. Need a whole new set up like a tent. Ha. So I really need some money.

The plants in my flower chamber are doing alright. I think 3 if not 4 have roots coming out now. Plants are still going to be small though.

Earlier this year I bought two Chicago electric 96 pin timers. Just opened them, set them, plugged them in and walked away. Just found out that they don't work. I should of known better than to trust anything from Chicago.

No sign of root bumps on my cuttings yet

How long has it been?

11-07-2012,*01:55 AM I started so closing on day 4. Seems like much longer. I saw people talk about the white bumps in 3 days with a fogger.

Hmm, I dunno.. Mine in rooters took 11-12 days. My fogger usually had root nubs in about a week. Hold steady.

Yeah I'll wait and see what happens. I'm sure it needs a taller container. It's throwing hot water up at the roots. The bottom of the lid is covered in warm water. Hopefully the ultrasonic fogger is keeping it sterilized.

Also thinking of making 1 inch neoprene disks to keep the top from getting wet

A couple of cuts that have been left in a cup of water appear to have white bumps.

The cuts with the fogger show nothing.