Week 6 of flower. Please help :)

S

Soyesevato

Member
I wasn't paying close enough attention and barely noticed this on many of my leaves. I'm in week 6 of flower and have had smooth sailing until now. I'm leaning towards calcium deficiency. I use coco and supplement with 2.5ml a gallon of calmag. Other than that I'm using the gh flora series
 

Attachments

PopAndSonGrows

PopAndSonGrows

Well-Known Member
If you're using RO or purified water, bump calmag up to like 4ml/gal. If you're using tap IMO drop the calmag entirely and see how things progress.

How many mls/gal of each of the trio are you using?
 
harrychilds

harrychilds

Well-Known Member
Soyesevato said:
I always feed it ph between 5.8 - 6.2
Click to expand...
  • Use nutrient solution that is at half your normal Inflow EC
  • Apply twice the normal quantity of water
  • Wait ten minutes following the application
  • Add additional dilute nutrient solution to produce new run-off for measure
  • Test the EC of this new run-off, it should be at or below your normal target inflow EC
  • If the EC is still high, repeat this process at the next opportunity to fertigate
 
harrychilds

harrychilds

Well-Known Member
Soyesevato said:
Correct
Click to expand...
Set your EC to 0.8
Apply twice the normal quantity of water
Wait ten minutes following the application
Add additional dilute nutrient solution to produce new run-off for measure
Test the EC of this new run-off, it should be at or below your normal target inflow EC
If the EC is still high, repeat this process at the next opportunity to fertigate
 
S

Soyesevato

Member
PopAndSonGrows said:
If you're using RO or purified water, bump calmag up to like 4ml/gal. If you're using tap IMO drop the calmag entirely and see how things progress.

How many mls/gal of each of the trio are you using?
Click to expand...
I use tap that's been through a PUR filter.

And I'm following the gh flora feeding chart
Micro 4.7ml
Gro 4.7 ml
Bloom 5.7 ml
 
S

Soyesevato

Member
harrychilds said:
Set your EC to 0.8
Apply twice the normal quantity of water
Wait ten minutes following the application
Add additional dilute nutrient solution to produce new run-off for measure
Test the EC of this new run-off, it should be at or below your normal target inflow EC
If the EC is still high, repeat this process at the next opportunity to fertigate
Click to expand...
So you think it's nutrient burn?
 
You must log in or register to reply here.
Top