yield estimate?

dbo24242

New Member
so these are about 9 days since pistils showed and have another 40-50 what kind of yield you think I'll get w/ this setup. the plants are about 3 ft high tho its hard to say exactly without a tape measure.

it is three plants in DWC using powerful 3 part salts. Flowering ~1500+ ppm already on res change, allowing res to drain and fill with water for about a wk and stocking a new one. using technaflora bloom, gh micro, foxfarm big bloom, but probably running out of tech soon and probably getting gh bloom and kool bloom to finish. ppms have been as high as 1800 on last res change with a lot of big bloom added.

lighting is a 1,000w as you can see it is a very small area for a 1,000w light, so there is 100w/sqft about and mylar all over. cooltube keeps temps within an ideal range and the 5" netpots I used are hosting some thick stems, almost an inch thick on the pe and the tw. there are 3 plants in this DWC. one is a sativa skunkberry type from clone, a pineapple express from seed, and a trainwreck from seed.
 

Attachments

  • 46e6d75e3a3debcbd7df4ca1947b44ba.jpg
    46e6d75e3a3debcbd7df4ca1947b44ba.jpg
    93.6 KB · Views: 549
  • DSCF0001.jpg
    DSCF0001.jpg
    84 KB · Views: 545
  • DSCF0002.jpg
    DSCF0002.jpg
    95.3 KB · Views: 547
it's way too early to be able to estimate, but i'd advise you to cut some of the lower branches so that the plants' energy goes towards the upper portion.
 
yeah I cut the bottom nodes off of all three plants, maybe like 2-4 nodes up, I could probably remove some more, but the light penetration is good enough that I want to just leave them.
 
Back
Top