Air circulation

Pmurp

Pmurp

Well-Known Member
I recently created a file cabinet stealth grow box with interior dimensions 15”x26.5”x40”.

I have the entire setup ready to go, however I’m extremely paranoid about air circulation through the canopy to disperse heat and strengthen stems. I had a smart devil 3 speed usb fan
(https://www.amazon.com/gp/aw/d/B07Q1GWVX5?psc=1&ref=ppx_pop_mob_b_asin_title)
mounted on the top of the cabinet pointing toward the canopy at 45° angle.

I’m worried that the fan isn’t enough to prevent bud rot. Do I ditch the fan and get a bigger one? Or is it good enough
 

Attachments

THC-CK

THC-CK

Well-Known Member
I have found with small cabs you want to mount your fans running with the longer length of the box. Ideally, make it so you can raise and lower this to be in line with the top of your canopy.

I used a 120mm computer fan mounted on skewers to slide up and down, it was very effective. And cheap.
 
Pmurp

Pmurp

Well-Known Member
THC-CK said:
I have found with small cabs you want to mount your fans running with the longer length of the box. Ideally, make it so you can raise and lower this to be in line with the top of your canopy.

I used a 120mm computer fan mounted on skewers to slide up and down, it was very effective. And cheap.
Click to expand...
Do you have pictures of the skewer set up?
 
THC-CK

THC-CK

Well-Known Member
Pmurp said:
Do you have pictures of the skewer set up?
Click to expand...
No, but all I did was glue two pieces of drinking straw to each side of the fan. Then built two 24" skewer "rails" for the fan to go up and down. Just used a piece of tape to hold it in place.
 
Pmurp

Pmurp

Well-Known Member
THC-CK said:
No, but all I did was glue two pieces of drinking straw to each side of the fan. Then built two 24" skewer "rails" for the fan to go up and down. Just used a piece of tape to hold it in place.
Click to expand...
That’s genius.
do you put the fan above or below a trellis net
 
Pmurp

Pmurp

Well-Known Member
THC-CK said:
My netting had an opening but I had two 120mm fans. One kept above the netting and one below.
Click to expand...
took your advice with a slight twist. 1/4” dowel from floor to ceiling with a bullnose binder clip to hold it in one steady direction, still adjustable
 

Attachments

You must log in or register to reply here.
Top